[PATCH v3 2/6] iio: adc: meson_saradc: Align messages to be with physical device prefix
Jonathan Cameron
jic23 at kernel.org
Fri Jun 3 09:21:17 PDT 2022
On Fri, 3 Jun 2022 13:00:00 +0300
Andy Shevchenko <andriy.shevchenko at linux.intel.com> wrote:
> Align messages to be printed with the physical device prefix as it's done
> everywhere else in this driver.
>
> Signed-off-by: Andy Shevchenko <andriy.shevchenko at linux.intel.com>
Here I'm fine with the use of the parent as can only happen after all
the setup is done, so it's obvious the parent will be assigned
(some might argue it is obvious in the previous patch, but I had to check
as I couldn't remember when we set it :)
Anyhow, LGTM.
> ---
> v3: new patch (inspired by previous change)
> drivers/iio/adc/meson_saradc.c | 7 +++----
> 1 file changed, 3 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/iio/adc/meson_saradc.c b/drivers/iio/adc/meson_saradc.c
> index 4fe6b997cd03..658047370db0 100644
> --- a/drivers/iio/adc/meson_saradc.c
> +++ b/drivers/iio/adc/meson_saradc.c
> @@ -345,6 +345,7 @@ static int meson_sar_adc_read_raw_sample(struct iio_dev *indio_dev,
> int *val)
> {
> struct meson_sar_adc_priv *priv = iio_priv(indio_dev);
> + struct device *dev = indio_dev->dev.parent;
> int regval, fifo_chan, fifo_val, count;
>
> if (!wait_for_completion_timeout(&priv->done,
> @@ -353,16 +354,14 @@ static int meson_sar_adc_read_raw_sample(struct iio_dev *indio_dev,
>
> count = meson_sar_adc_get_fifo_count(indio_dev);
> if (count != 1) {
> - dev_err(&indio_dev->dev,
> - "ADC FIFO has %d element(s) instead of one\n", count);
> + dev_err(dev, "ADC FIFO has %d element(s) instead of one\n", count);
> return -EINVAL;
> }
>
> regmap_read(priv->regmap, MESON_SAR_ADC_FIFO_RD, ®val);
> fifo_chan = FIELD_GET(MESON_SAR_ADC_FIFO_RD_CHAN_ID_MASK, regval);
> if (fifo_chan != chan->address) {
> - dev_err(&indio_dev->dev,
> - "ADC FIFO entry belongs to channel %d instead of %lu\n",
> + dev_err(dev, "ADC FIFO entry belongs to channel %d instead of %lu\n",
> fifo_chan, chan->address);
> return -EINVAL;
> }
More information about the linux-amlogic
mailing list