[PATCH v3 3/4] irqchip/meson-gpio: add select trigger type callback

Qianggui Song qianggui.song at amlogic.com
Thu Feb 24 21:52:05 PST 2022


Due to some chips may use different registers and offset, provide
a set trigger type call back and add one for old controller.

Signed-off-by: Qianggui Song <qianggui.song at amlogic.com>
---
 drivers/irqchip/irq-meson-gpio.c | 20 +++++++++++++-------
 1 file changed, 13 insertions(+), 7 deletions(-)

diff --git a/drivers/irqchip/irq-meson-gpio.c b/drivers/irqchip/irq-meson-gpio.c
index 63841e1578f5..7b5863e36816 100644
--- a/drivers/irqchip/irq-meson-gpio.c
+++ b/drivers/irqchip/irq-meson-gpio.c
@@ -51,11 +51,15 @@ static void meson_a1_gpio_irq_sel_pin(struct meson_gpio_irq_controller *ctl,
 				      unsigned int channel,
 				      unsigned long hwirq);
 static void meson_a1_gpio_irq_init(struct meson_gpio_irq_controller *ctl);
+static int meson8_gpio_irq_set_type(struct meson_gpio_irq_controller *ctl,
+				    unsigned int type, u32 *channel_hwirq);
 
 struct irq_ctl_ops {
 	void (*gpio_irq_sel_pin)(struct meson_gpio_irq_controller *ctl,
 				 unsigned int channel, unsigned long hwirq);
 	void (*gpio_irq_init)(struct meson_gpio_irq_controller *ctl);
+	int (*gpio_irq_set_type)(struct meson_gpio_irq_controller *ctl,
+				 unsigned int type, u32 *channel_hwirq);
 };
 
 struct meson_gpio_irq_params {
@@ -69,16 +73,18 @@ struct meson_gpio_irq_params {
 	struct irq_ctl_ops ops;
 };
 
-#define INIT_MESON_COMMON(irqs, init, sel)			\
+#define INIT_MESON_COMMON(irqs, init, sel, type)		\
 	.nr_hwirq = irqs,					\
 	.ops = {						\
 		.gpio_irq_init = init,				\
 		.gpio_irq_sel_pin = sel,			\
+		.gpio_irq_set_type = type,			\
 	},
 
 #define INIT_MESON8_COMMON_DATA(irqs)				\
 	INIT_MESON_COMMON(irqs, meson_gpio_irq_init_dummy,	\
-			  meson8_gpio_irq_sel_pin)		\
+			  meson8_gpio_irq_sel_pin,		\
+			  meson8_gpio_irq_set_type)		\
 	.edge_single_offset = 0,				\
 	.pol_low_offset = 16,					\
 	.pin_sel_mask = 0xff,					\
@@ -86,7 +92,8 @@ struct meson_gpio_irq_params {
 
 #define INIT_MESON_A1_COMMON_DATA(irqs)				\
 	INIT_MESON_COMMON(irqs, meson_a1_gpio_irq_init,		\
-			  meson_a1_gpio_irq_sel_pin)		\
+			  meson_a1_gpio_irq_sel_pin,		\
+			  meson8_gpio_irq_set_type)		\
 	.support_edge_both = true,				\
 	.edge_both_offset = 16,					\
 	.edge_single_offset = 8,				\
@@ -259,9 +266,8 @@ meson_gpio_irq_release_channel(struct meson_gpio_irq_controller *ctl,
 	clear_bit(idx, ctl->channel_map);
 }
 
-static int meson_gpio_irq_type_setup(struct meson_gpio_irq_controller *ctl,
-				     unsigned int type,
-				     u32 *channel_hwirq)
+static int meson8_gpio_irq_set_type(struct meson_gpio_irq_controller *ctl,
+				    unsigned int type, u32 *channel_hwirq)
 {
 	u32 val = 0;
 	unsigned int idx;
@@ -326,7 +332,7 @@ static int meson_gpio_irq_set_type(struct irq_data *data, unsigned int type)
 	u32 *channel_hwirq = irq_data_get_irq_chip_data(data);
 	int ret;
 
-	ret = meson_gpio_irq_type_setup(ctl, type, channel_hwirq);
+	ret = ctl->params->ops.gpio_irq_set_type(ctl, type, channel_hwirq);
 	if (ret)
 		return ret;
 
-- 
2.34.1




More information about the linux-amlogic mailing list