[PATCH v2 6/6] drm/meson: encoder_cvbs: switch to bridge with ATTACH_NO_CONNECTOR

[Martin Blumenstingl]

Hi Neil, Hi Sam,

On Fri, Oct 15, 2021 at 4:11 PM Neil Armstrong <narmstrong at baylibre.com> wrote:
[...]
> +static const struct drm_bridge_funcs meson_encoder_cvbs_bridge_funcs = {
> +       .attach = meson_encoder_cvbs_attach,
> +       .enable = meson_encoder_cvbs_enable,
> +       .disable = meson_encoder_cvbs_disable,
> +       .mode_valid = meson_encoder_cvbs_mode_valid,
> +       .get_modes = meson_encoder_cvbs_get_modes,
> +       .atomic_enable = meson_encoder_cvbs_atomic_enable,
I did some testing on boards where u-boot doesn't initialize the video outputs.
It seems that meson_encoder_cvbs_enable() is never called with this patch.
meson_encoder_cvbs_atomic_enable() is called though.

>From what I can see in drm_bridge.c [0] this is even expected.
Does this mean that we need to move all logic from .enable to
.atomic_enable (and same with .disable -> moving that logic to
.atomic_disable)?

The same comment applies to the HDMI patch.


Best regards,
Martin


[0] https://elixir.bootlin.com/linux/v5.15-rc5/source/drivers/gpu/drm/drm_bridge.c#L717