[PATCH v3 2/3] usb: dwc3: meson-g12a: fix shared reset control use
Amjad Ouled-Ameur
aouledameur at baylibre.com
Fri Nov 12 08:28:26 PST 2021
reset_control_(de)assert() calls are called on a shared reset line when
reset_control_reset has been used. This is not allowed by the reset
framework.
Use reset_control_rearm() call in suspend() and remove() as a way to state
that the resource is no longer used, hence the shared reset line
may be triggered again by other devices. Use reset_control_rearm() also in
case probe fails after reset() has been called.
reset_control_rearm() keeps use of triggered_count sane in the reset
framework, use of reset_control_reset() on shared reset line should be
balanced with reset_control_rearm().
Signed-off-by: Amjad Ouled-Ameur <aouledameur at baylibre.com>
Reported-by: Jerome Brunet <jbrunet at baylibre.com>
---
drivers/usb/dwc3/dwc3-meson-g12a.c | 17 ++++++++++++-----
1 file changed, 12 insertions(+), 5 deletions(-)
diff --git a/drivers/usb/dwc3/dwc3-meson-g12a.c b/drivers/usb/dwc3/dwc3-meson-g12a.c
index d0f9b7c296b0..bd814df3bf8b 100644
--- a/drivers/usb/dwc3/dwc3-meson-g12a.c
+++ b/drivers/usb/dwc3/dwc3-meson-g12a.c
@@ -755,16 +755,16 @@ static int dwc3_meson_g12a_probe(struct platform_device *pdev)
ret = dwc3_meson_g12a_get_phys(priv);
if (ret)
- goto err_disable_clks;
+ goto err_rearm;
ret = priv->drvdata->setup_regmaps(priv, base);
if (ret)
- goto err_disable_clks;
+ goto err_rearm;
if (priv->vbus) {
ret = regulator_enable(priv->vbus);
if (ret)
- goto err_disable_clks;
+ goto err_rearm;
}
/* Get dr_mode */
@@ -825,6 +825,9 @@ static int dwc3_meson_g12a_probe(struct platform_device *pdev)
if (priv->vbus)
regulator_disable(priv->vbus);
+err_rearm:
+ reset_control_rearm(priv->reset);
+
err_disable_clks:
clk_bulk_disable_unprepare(priv->drvdata->num_clks,
priv->drvdata->clks);
@@ -852,6 +855,8 @@ static int dwc3_meson_g12a_remove(struct platform_device *pdev)
pm_runtime_put_noidle(dev);
pm_runtime_set_suspended(dev);
+ reset_control_rearm(priv->reset);
+
clk_bulk_disable_unprepare(priv->drvdata->num_clks,
priv->drvdata->clks);
@@ -892,7 +897,7 @@ static int __maybe_unused dwc3_meson_g12a_suspend(struct device *dev)
phy_exit(priv->phys[i]);
}
- reset_control_assert(priv->reset);
+ reset_control_rearm(priv->reset);
return 0;
}
@@ -902,7 +907,9 @@ static int __maybe_unused dwc3_meson_g12a_resume(struct device *dev)
struct dwc3_meson_g12a *priv = dev_get_drvdata(dev);
int i, ret;
- reset_control_deassert(priv->reset);
+ ret = reset_control_reset(priv->reset);
+ if (ret)
+ return ret;
ret = priv->drvdata->usb_init(priv);
if (ret)
--
2.25.1
More information about the linux-amlogic
mailing list