[PATCH v2] clk: meson: meson8b: Use CLK_SET_RATE_NO_REPARENT for vclk{,2}_in_sel

[Jerome Brunet]

On Mon 24 May 2021 at 15:45, Martin Blumenstingl <martin.blumenstingl at googlemail.com> wrote:

> Use CLK_SET_RATE_NO_REPARENT for the vclk{,2}_in_sel clocks. The only
> parent which is actually used is vid_pll_final_div. This should be set
> using assigned-clock-parents in the .dts rather than removing some
> "unwanted" clock parents from the clock driver.
>
> Suggested-by: Jerome Brunet <jbrunet at baylibre.com>
> Signed-off-by: Martin Blumenstingl <martin.blumenstingl at googlemail.com>
> ---
> After a hint from Jerome (thanks) this is the improved version of
> "clk: meson: meson8b: Don't use MPLL1 as parent of vclk_in_sel" from [0]
>
>
> [0] https://patchwork.kernel.org/project/linux-clk/patch/20210524104533.555953-1-martin.blumenstingl@googlemail.com/
>
>
>  drivers/clk/meson/meson8b.c | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/clk/meson/meson8b.c b/drivers/clk/meson/meson8b.c
> index a844d35b553a..0f8bd707217a 100644
> --- a/drivers/clk/meson/meson8b.c
> +++ b/drivers/clk/meson/meson8b.c
> @@ -1175,7 +1175,7 @@ static struct clk_regmap meson8b_vclk_in_sel = {
>  		.ops = &clk_regmap_mux_ro_ops,

I just noticed that these muxes are read-only ATM.
It does not make this change (or the previous one) wrong but it does not
make much sense as the mux won't ever change.

I suppose you make this mutable with another patch later on ?


>  		.parent_hws = meson8b_vclk_mux_parent_hws,
>  		.num_parents = ARRAY_SIZE(meson8b_vclk_mux_parent_hws),
> -		.flags = CLK_SET_RATE_PARENT,
> +		.flags = CLK_SET_RATE_PARENT | CLK_SET_RATE_NO_REPARENT,
>  	},
>  };
>  
> @@ -1358,7 +1358,7 @@ static struct clk_regmap meson8b_vclk2_in_sel = {
>  		.ops = &clk_regmap_mux_ro_ops,
>  		.parent_hws = meson8b_vclk_mux_parent_hws,
>  		.num_parents = ARRAY_SIZE(meson8b_vclk_mux_parent_hws),
> -		.flags = CLK_SET_RATE_PARENT,
> +		.flags = CLK_SET_RATE_PARENT | CLK_SET_RATE_NO_REPARENT,
>  	},
>  };