[PATCH RFC v1 1/3] clk: divider: Add re-usable determine_rate implementations
Jerome Brunet
jbrunet at baylibre.com
Wed May 19 05:31:41 PDT 2021
On Tue 18 May 2021 at 22:33, Martin Blumenstingl <martin.blumenstingl at googlemail.com> wrote:
> Hi Jerome,
>
> On Tue, May 18, 2021 at 9:44 AM Jerome Brunet <jbrunet at baylibre.com> wrote:
> [...]
>> > +int divider_ro_determine_rate(struct clk_hw *hw, struct clk_rate_request *req,
>> > + const struct clk_div_table *table, u8 width,
>> > + unsigned long flags, unsigned int val)
>> > +{
>> > + int div;
>> > +
>> > + div = _get_div(table, val, flags, width);
>> > +
>> > + /* Even a read-only clock can propagate a rate change */
>> > + if (clk_hw_get_flags(hw) & CLK_SET_RATE_PARENT) {
>> > + if (!req->best_parent_hw)
>> > + return -EINVAL;
>> > +
>> > + req->best_parent_rate = clk_hw_round_rate(req->best_parent_hw,
>> > + req->rate * div);
>> > + }
>> > +
>> > + req->rate = DIV_ROUND_UP_ULL((u64)req->best_parent_rate, div);
>> > +
>> > + return 0;
>> > +}
>> > +EXPORT_SYMBOL_GPL(divider_ro_determine_rate);
>>
>> For a final version, could you factorize the code with the .round_rate()
>> variant ? It would remove a bit of duplication.
> my first idea was to basically let the new _determine_rate code just
> forward all relevant parameters to _round_rate
> however, I discarded that as it turned out to be less understandable
> for me as parameters need to be mapped in both ways
>
> while writing this mail I noticed that the opposite direction
> (meaning: _round_rate forwards to _determine_rate) will probably work.
> I'll give it a try in the next days
> if you had anything else in mind then please let me know
Yep, the idea would be to use the determine_rate() part as the common
implementation. AFAICT, all you need is to build req_rate structure in
the round_rate() part.
>
>> Maybe determine_rate() can also replace round_rate() in the generic
>> divider ops ?
> sure, I'll add that as a separate patch in this series
> note to myself: testing can be done with the MMC drivers as we're
> using the generic clk_divider_ops there
>
>
> Best regards,
> Martin
More information about the linux-amlogic
mailing list