[PATCHv1 1/3] ARM: dts: meson8b: odroidc1: Add usb phy power node
Martin Blumenstingl
martin.blumenstingl at googlemail.com
Tue Jul 13 08:05:20 PDT 2021
Hi Anand,
On Tue, Jul 13, 2021 at 7:53 AM Anand Moon <linux.amoon at gmail.com> wrote:
>
> Add missing usb phy power node for phy mode fix below warning.
>
> [ 1.253149] phy phy-c1108820.phy.0: Looking up phy-supply from device tree
> [ 1.253166] phy phy-c1108820.phy.0: Looking up phy-supply property
> in node /soc/cbus at c1100000/phy at 8820 failed
I did some testing on my own Odroid-C1+ and this patch is not doing
anything for me.
more information below.
[...]
> + /*
> + * signal name from schematics: USB_POWER
> + */
Just a few lines below you're saying that the name from the schematics is PWREN
If this patch is getting another round then please clarify the actual
signal name, or name both signals if the schematics is actually using
both names.
[...]
> + gpio = <&gpio_ao GPIOAO_5 GPIO_ACTIVE_HIGH>;
> + enable-active-high;
I booted my Odroid-C1+ with this and USB was working fine.
Then I replaced these two lines with:
gpio = <&gpio_ao GPIOAO_5 GPIO_ACTIVE_LOW>;
and I found that USB is still working.
Can you please give this a try on your Odroid-C1 as well?
The conclusion from my own testing is that GPIOAO_5 doesn't seem to be
related to USB1 (host-only) because if it was then inverting the
polarity (from active high to active low) should result in a change.
[...]
> &usb1_phy {
> status = "okay";
> + phy-supply = <&usb_pwr_en>;
>From the schematics it seems that this is not the PHY supply (which I
admittedly have used incorrectly for VBUS before).
In the schematics that I have (odroid-c1+_rev0.4_20150615.pdf) it
seems to be enabling VBUS.
So in that case a vbus-supply property should be used inside &usb1 instead.
Best regards,
Martin
More information about the linux-amlogic
mailing list