[PATCH v5 1/3] phy: amlogic: phy-meson-gxl-usb2: fix shared reset controller use
Amjad Ouled-Ameur
aouledameur at baylibre.com
Sun Dec 12 12:18:42 PST 2021
Use reset_control_rearm() call if an error occurs in case
phy_meson_gxl_usb2_init() fails after reset() has been called ; or in case
phy_meson_gxl_usb2_exit() is called i.e the resource is no longer used
and the reset line may be triggered again by other devices.
reset_control_rearm() keeps use of triggered_count sane in the reset
framework. Therefore, use of reset_control_reset() on shared reset line
should be balanced with reset_control_rearm().
Signed-off-by: Amjad Ouled-Ameur <aouledameur at baylibre.com>
Reported-by: Jerome Brunet <jbrunet at baylibre.com>
---
changes since v4:
- Call reset_control_rearm() after clk_prepare_enable() fails
drivers/phy/amlogic/phy-meson-gxl-usb2.c | 5 ++++-
1 file changed, 4 insertions(+), 1 deletion(-)
diff --git a/drivers/phy/amlogic/phy-meson-gxl-usb2.c b/drivers/phy/amlogic/phy-meson-gxl-usb2.c
index 2b3c0d730f20..db17c3448bfe 100644
--- a/drivers/phy/amlogic/phy-meson-gxl-usb2.c
+++ b/drivers/phy/amlogic/phy-meson-gxl-usb2.c
@@ -114,8 +114,10 @@ static int phy_meson_gxl_usb2_init(struct phy *phy)
return ret;
ret = clk_prepare_enable(priv->clk);
- if (ret)
+ if (ret) {
+ reset_control_rearm(priv->reset);
return ret;
+ }
return 0;
}
@@ -125,6 +127,7 @@ static int phy_meson_gxl_usb2_exit(struct phy *phy)
struct phy_meson_gxl_usb2_priv *priv = phy_get_drvdata(phy);
clk_disable_unprepare(priv->clk);
+ reset_control_rearm(priv->reset);
return 0;
}
--
2.25.1
More information about the linux-amlogic
mailing list