[PATCH] serial: meson: make the current driver compatible with S4

Martin Blumenstingl martin.blumenstingl at googlemail.com
Mon Dec 6 13:31:16 PST 2021


Hi,

On Mon, Dec 6, 2021 at 11:02 AM xianwei.zhao <xianwei.zhao at amlogic.com> wrote:
>
> Because S4 UART use a different clock source, the baud rate calculation need to be updated.
> Reset the UART during initialization to clear previous status.
Could you please explain why it is needed (is the divide-by-three
divider broken, does this patch decrease clock jitter, ...)?
Think of it like this: if I add another Amlogic board.dts tomorrow,
then how do I know when the "xtal_tick_en" property needs to be set?

I found that the public datasheet for the A311D SoC already mentions
AML_UART_BAUD_XTAL_TICK and AML_UART_BAUD_XTAL_DIV2 but so far UART is
working fine on that SoC even without this patch.

[...]
> +       val = readl_relaxed(port->membase + AML_UART_REG5);
The old logic worked like this:
- calculate the new register values
- write "val" to the register

The new logic uses many extra steps:
- read the existing register value
- mask off some bits in the "val" variable
- update some bits in the "val" variable based on the calculations below
- write "val" to the register

Is there any reason why we need to change this logic to set AML_UART_REG5?


Best regards,
Martin



More information about the linux-amlogic mailing list