[PATCH v2 0/5] usb: dwc-meson-g12a: Add support for USB on S400 board

Kevin Hilman khilman at baylibre.com
Fri Oct 2 14:23:46 EDT 2020


Neil Armstrong <narmstrong at baylibre.com> writes:

> Hi Kevin,
>
> On 17/09/2020 08:59, Neil Armstrong wrote:
>> The Amlogic AXG is close to the GXL Glue but with a single OTG PHY.
>> 
>> It needs the same init sequence as GXL & GXM, but it seems it doesn't need
>> the host disconnect bit.
>> 
>> The Glue driver reuses the already implemented GXL & GXM work.
>> 
>> The USB2 PHY driver needs a slight tweak to keep the OTG detection working.
>> 
>> Changes since v1 at [1]:
>> - s/close from/close to/g
>> - collected review tags
>> - added small comment about phy management in patch 3
>> - removed status = "okay" in patch 4
>> - removed invalid phy-supply of phy1 in patch 5
>> 
>> [1] http://lore.kernel.org/r/20200909160409.8678-1-narmstrong@baylibre.com
>> 
>> Neil Armstrong (5):
>>   phy: amlogic: phy-meson-gxl-usb2: keep ID pull-up even in Host mode
>>   dt-bindings: usb: amlogic,meson-g12a-usb-ctrl: add the Amlogic AXG
>>     Families USB Glue Bindings
>>   usb: dwc-meson-g12a: Add support for USB on AXG SoCs
>>   arm64: dts: meson-axg: add USB nodes
>>   arm64: dts: meson-axg-s400: enable USB OTG
>
> Can you pick the DT patches ?

Yes, queued up.

Since we're already at -rc7, this may not make it until v5.11.

Kevin



More information about the linux-amlogic mailing list