[PATCH v2 4/5] arm64: dts: meson: g12a: x96-max: fix PHY deassert timing requirements

Stefan Agner stefan at agner.ch
Tue Dec 1 08:21:40 EST 2020


According to the datasheet (Rev. 1.9) the RTL8211F requires at least
72ms "for internal circuits settling time" before accessing the PHY
egisters. On similar boards with the same PHY this fixes an issue where
Ethernet link would not come up when using ip link set down/up.

Fixes: ed5e8f689154 ("arm64: dts: meson: g12a: x96-max: fix the Ethernet PHY reset line")
Signed-off-by: Stefan Agner <stefan at agner.ch>
---
 arch/arm64/boot/dts/amlogic/meson-g12a-x96-max.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/amlogic/meson-g12a-x96-max.dts b/arch/arm64/boot/dts/amlogic/meson-g12a-x96-max.dts
index 1b07c8c06eac..463a72d6bb7c 100644
--- a/arch/arm64/boot/dts/amlogic/meson-g12a-x96-max.dts
+++ b/arch/arm64/boot/dts/amlogic/meson-g12a-x96-max.dts
@@ -340,7 +340,7 @@ external_phy: ethernet-phy at 0 {
 		eee-broken-1000t;
 
 		reset-assert-us = <10000>;
-		reset-deassert-us = <30000>;
+		reset-deassert-us = <80000>;
 		reset-gpios = <&gpio GPIOZ_15 (GPIO_ACTIVE_LOW | GPIO_OPEN_DRAIN)>;
 
 		interrupt-parent = <&gpio_intc>;
-- 
2.29.2




More information about the linux-amlogic mailing list