[PATCH v2 5/6] arm64: dts: meson-g12a: Add PCIe node

Neil Armstrong narmstrong at baylibre.com
Mon Sep 16 05:50:21 PDT 2019


This adds the Amlogic G12A PCI Express controller node, also
using the USB3+PCIe Combo PHY.

The PHY mode selection is static, thus the USB3+PCIe Combo PHY
phandle would need to be removed from the USB control node if the
shared differential lines are used for PCIe instead of USB3.

Signed-off-by: Neil Armstrong <narmstrong at baylibre.com>
---
 .../boot/dts/amlogic/meson-g12-common.dtsi    | 33 +++++++++++++++++++
 arch/arm64/boot/dts/amlogic/meson-sm1.dtsi    |  4 +++
 2 files changed, 37 insertions(+)

diff --git a/arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi b/arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi
index 852cf9cf121b..7330dc37b7a6 100644
--- a/arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi
+++ b/arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi
@@ -95,6 +95,39 @@
 		#size-cells = <2>;
 		ranges;
 
+		pcie: pcie at fc000000 {
+			compatible = "amlogic,g12a-pcie", "snps,dw-pcie";
+			reg = <0x0 0xfc000000 0x0 0x400000
+			       0x0 0xff648000 0x0 0x2000
+			       0x0 0xfc400000 0x0 0x200000>;
+			reg-names = "elbi", "cfg", "config";
+			interrupts = <GIC_SPI 221 IRQ_TYPE_LEVEL_HIGH>;
+			#interrupt-cells = <1>;
+			interrupt-map-mask = <0 0 0 0>;
+			interrupt-map = <0 0 0 0 &gic GIC_SPI 223 IRQ_TYPE_LEVEL_HIGH>;
+			bus-range = <0x0 0xff>;
+			#address-cells = <3>;
+			#size-cells = <2>;
+			device_type = "pci";
+			ranges = <0x81000000 0 0 0x0 0xfc600000 0 0x00100000
+				  0x82000000 0 0xfc700000 0x0 0xfc700000 0 0x1900000>;
+
+			clocks = <&clkc CLKID_PCIE_PHY
+				  &clkc CLKID_PCIE_COMB
+				  &clkc CLKID_PCIE_PLL>;
+			clock-names = "general",
+				      "pclk",
+				      "port";
+			resets = <&reset RESET_PCIE_CTRL_A>,
+				 <&reset RESET_PCIE_APB>;
+			reset-names = "port",
+				      "apb";
+			num-lanes = <1>;
+			phys = <&usb3_pcie_phy PHY_TYPE_PCIE>;
+			phy-names = "pcie";
+			status = "disabled";
+		};
+
 		ethmac: ethernet at ff3f0000 {
 			compatible = "amlogic,meson-axg-dwmac",
 				     "snps,dwmac-3.70a",
diff --git a/arch/arm64/boot/dts/amlogic/meson-sm1.dtsi b/arch/arm64/boot/dts/amlogic/meson-sm1.dtsi
index 91492819d0d8..ee9ea3c69433 100644
--- a/arch/arm64/boot/dts/amlogic/meson-sm1.dtsi
+++ b/arch/arm64/boot/dts/amlogic/meson-sm1.dtsi
@@ -135,6 +135,10 @@
 	power-domains = <&pwrc PWRC_SM1_ETH_ID>;
 };
 
+&pcie {
+	power-domains = <&pwrc PWRC_SM1_PCIE_ID>;
+};
+
 &pwrc {
 	compatible = "amlogic,meson-sm1-pwrc";
 };
-- 
2.22.0




More information about the linux-amlogic mailing list