[PATCH v5 2/2] mtd: rawnand: meson: add support for Amlogic NAND flash controller

Liang Yang liang.yang at amlogic.com
Fri Oct 19 00:29:13 PDT 2018



On 2018/10/18 22:24, Boris Brezillon wrote:
> On Thu, 18 Oct 2018 13:09:05 +0800
> Jianxin Pan <jianxin.pan at amlogic.com> wrote:
> 
>> +static int meson_nfc_exec_op(struct nand_chip *chip,
>> +			     const struct nand_operation *op, bool check_only)
>> +{
>> +	struct mtd_info *mtd = nand_to_mtd(chip);
>> +	struct meson_nfc *nfc = nand_get_controller_data(chip);
>> +	const struct nand_op_instr *instr = NULL;
>> +	int ret = 0, cmd;
>> +	unsigned int op_id;
>> +	int i;
>> +
>> +	for (op_id = 0; op_id < op->ninstrs; op_id++) {
>> +		instr = &op->instrs[op_id];
>> +		switch (instr->type) {
>> +		case NAND_OP_CMD_INSTR:
>> +			if (instr->ctx.cmd.opcode == NAND_CMD_STATUS)
>> +				meson_nfc_cmd_idle(nfc, nfc->timing.twb);
> 
> Hm, I don't want drivers to base their decisions on the opcode value.
> There's a ->delay_ns field in the instruction object, can't you use
> that one instead? Also, I don't understand why this is only needed for
> the STATUS command. It should normally be applied to all instructions.
> 
em, it should be applied to all instructions.
i will fix it and use instr->delay_ns instead.

>> +			cmd = nfc->param.chip_select | NFC_CMD_CLE;
>> +			cmd |= instr->ctx.cmd.opcode & 0xff;
>> +			writel(cmd, nfc->reg_base + NFC_REG_CMD);
>> +			if (instr->ctx.cmd.opcode == NAND_CMD_STATUS)
>> +				meson_nfc_cmd_idle(nfc, nfc->timing.twhr);
>> +			break;
>> +
>> +		case NAND_OP_ADDR_INSTR:
>> +			for (i = 0; i < instr->ctx.addr.naddrs; i++) {
>> +				cmd = nfc->param.chip_select | NFC_CMD_ALE;
>> +				cmd |= instr->ctx.addr.addrs[i] & 0xff;
>> +				writel(cmd, nfc->reg_base + NFC_REG_CMD);
>> +			}
>> +			break;
>> +
>> +		case NAND_OP_DATA_IN_INSTR:
>> +			meson_nfc_read_buf(mtd, instr->ctx.data.buf.in,
>> +					   instr->ctx.data.len);
>> +			break;
>> +
>> +		case NAND_OP_DATA_OUT_INSTR:
>> +			meson_nfc_write_buf(mtd, instr->ctx.data.buf.out,
>> +					    instr->ctx.data.len);
>> +			break;
>> +
>> +		case NAND_OP_WAITRDY_INSTR:
>> +			meson_nfc_queue_rb(nfc, instr->ctx.waitrdy.timeout_ms);
>> +			break;
>> +		}
>> +	}
>> +	return ret;
>> +}
> 
> .
> 



More information about the linux-amlogic mailing list