[PATCH v2 0/4] Meson8m2 (32-bit ARM) SoC support

Kevin Hilman khilman at baylibre.com
Thu May 10 17:33:43 PDT 2018

Martin Blumenstingl <martin.blumenstingl at googlemail.com> writes:

> This series adds support for the Meson8m2 SoC. This SoC is mostly
> compatible with Meson8 while using some peripherals from Meson8b. Patch
> #4 contains a list of (known) differences between the Meson8 and Meson8m2
> SoCs.
> The first supported board with Meson8m2 SoC is the "Tronsmart MXIII Plus"
> where Oleg contributed the initial .dts and heavily tested it (many
> thanks!). His testing also confirmed that the Meson8m2 SoC uses the same
> register layout for the Ethernet "glue registers (supported by the
> dwmac-meson8b driver) as Meson8b.
> changes since v1 at [0]:
> - do not create a new MACH_MESON8M2 Kconfig entry as suggested by Kevin
>   (MACH_MESON8 is re-used instead). This affects patch #1 (which was
>   patch #3 in v1) and patch #4 (which was patch #6 in v1)
> - dropped patches #1 and #2 from v1 because Kevin already applied these
>   ("dt-bindings: arm: amlogic: add support for the Meson8m2 SoC" and
>   "dt-bindings: arm: amlogic: add support for the Tronsmart MXIII Plus")

Applied to v4.18/dt.

One more request: Could you send one more patch (on top of my v4.18/dt)
that gets rid of the Kconfig for the 8B also?



More information about the linux-amlogic mailing list