[PATCH 2/2] ARM: dts: meson8b-odroidc1: ethernet support

Emiliano Ingrassia ingrassia at epigenesys.com
Mon Jan 15 16:34:43 PST 2018


The Odroid-C1+ board is equipped with an RTL8211F ethernet PHY
which supports 10/100/1000 Mbps ethernet.
This patch adds the PHY description to the board DT,
setting the maximum speed to 1 Gbps, and enables the ethernet controller.

Signed-off-by: Emiliano Ingrassia <ingrassia at epigenesys.com>
---
 arch/arm/boot/dts/meson8b-odroidc1.dts | 32 ++++++++++++++++++++++++++++++++
 1 file changed, 32 insertions(+)

diff --git a/arch/arm/boot/dts/meson8b-odroidc1.dts b/arch/arm/boot/dts/meson8b-odroidc1.dts
index 9ff6ca4e20d0..3766f6fd1882 100644
--- a/arch/arm/boot/dts/meson8b-odroidc1.dts
+++ b/arch/arm/boot/dts/meson8b-odroidc1.dts
@@ -99,3 +99,35 @@
 &usb1 {
 	status = "okay";
 };
+
+&ethmac {
+	status = "okay";
+
+	snps,reset-gpio = <&gpio GPIOH_4 GPIO_ACTIVE_HIGH>;
+	snps,reset-active-low;
+	snps,reset-delays-us = <0 10000 30000>;
+
+	pinctrl-0 = <&eth_rgmii_pins>;
+	pinctrl-names = "default";
+
+	phy-mode = "rgmii";
+	phy-handle = <&eth_phy>;
+	amlogic,tx-delay-ns = <4>;
+
+	mdio {
+		compatible = "snps,dwmac-mdio";
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		eth_phy: ethernet-phy at 0 {
+			/* ethernet PHY RTL8211F */
+			compatible = "ethernet-phy-id001c.c916",
+				     "ethernet-phy-ieee802.3-c22";
+			reg = <0>;
+			max-speed = <1000>;
+			eee-broken-1000t;
+			interrupt-parent = <&gpio_intc>;
+			interrupts = <17 IRQ_TYPE_LEVEL_LOW>;
+		};
+	};
+};
-- 
2.15.1




More information about the linux-amlogic mailing list