[PATCH 01/33] clk_ops: change round_rate() to return unsigned long
pure.logic at nexus-software.ie
Tue Jan 2 12:43:44 PST 2018
On 02/01/18 19:01, Stephen Boyd wrote:
> On 12/31, Bryan O'Donoghue wrote:
>> On 30/12/17 16:36, Mikko Perttunen wrote:
>>> FWIW, we had this problem some years ago with the Tegra CPU clock
>>> - then it was determined that a simpler solution was to have the
>>> determine_rate callback support unsigned long rates - so clock
>>> drivers that need to return rates higher than 2^31 can instead
>>> implement the determine_rate callback. That is what's currently
>> Granted we could work around it but, having both zero and less than
>> zero indicate error means you can't support larger than LONG_MAX
>> which is I think worth fixing.
> Ok. But can you implement the determine_rate op instead of the
> round_rate op for your clk?
Don't know .
> It's not a work-around, it's the
> preferred solution. That would allow rates larger than 2^31 for
> the clk without pushing through a change to all the drivers to
> express zero as "error" and non-zero as the rounded rate.
> I'm not entirely opposed to this approach, because we probably
> don't care to pass the particular error value from a clk provider
> to a clk consumer about what the error is.
Which was my thought. The return value of clk_ops->round_rate() appears
not to get pushed up the stack, which is what the last patch in this
series deals with.
[PATCH 33/33] clk: change handling of round_rate() such that only zero
is an error
> It's actually what we
> proposed as the solution for clk_round_rate() to return values
> larger than LONG_MAX to consumers. But doing that consumer API
> change or this provider side change is going to require us to
> evaluate all the consumers of these clks to make sure they don't
> check for some error value that's less than zero. This series
> does half the work,
Do you mean users of clk_rounda_rate() ? I have a set of patches for
that but wanted to separate that from clk_ops->round_rate() so as not to
send ~70 patches out to LKML at once - even if they are in two blocks.
If so, I can publish that set too for reference.
AFAICT on clk_ops->round_rate the last patch #33 ought to cover the
usage of the return value of clk_ops->round_rate().
Have I missed something ?
> by changing the provider side, while ignoring
> the consumer side and any potential fallout of the less than zero
> to zero return value change.
Can you look at #33 ? I'm not sure if you saw that one.
More information about the linux-amlogic