[RFC v2 2/9] dt-bindings: net: bluetooth: add support for Realtek Bluetooth chips

[Marcel Holtmann]

Hi Martin,

> This adds the documentation for Bluetooth functionality of the Realtek
> RTL8723BS and RTL8723DS.
> Both are SDIO wifi chips with an additional Bluetooth module which is
> connected via UART to the host.
> 
> Signed-off-by: Martin Blumenstingl <martin.blumenstingl at googlemail.com>
> ---
> .../devicetree/bindings/net/realtek-bluetooth.txt  | 41 ++++++++++++++++++++++
> 1 file changed, 41 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/net/realtek-bluetooth.txt
> 
> diff --git a/Documentation/devicetree/bindings/net/realtek-bluetooth.txt b/Documentation/devicetree/bindings/net/realtek-bluetooth.txt
> new file mode 100644
> index 000000000000..1491329c4cd1
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/net/realtek-bluetooth.txt
> @@ -0,0 +1,41 @@
> +Realtek Bluetooth Chips
> +-----------------------
> +
> +This documents the binding structure and common properties for serial
> +attached Realtek devices.
> +
> +Serial attached Realtek devices shall be a child node of the host UART
> +device the slave device is attached to. See ../serial/slave-device.txt
> +for more information
> +
> +Required properties:
> +- compatible: should contain one of the following:
> +    * "realtek,rtl8723bs-bluetooth"
> +    * "realtek,rtl8723ds-bluetooth"
> +
> +Optional properties:
> +- realtek,config-data: Bluetooth chipset configuration data which is
> +			needed for communication (it typically contains
> +			board specific settings like the baudrate and
> +			whether flow-control is used).
> +			This is an array of u8 values.

any chance we can at least include the basic format of these config blobs. And I prefer at least an ACK from Rob here.

> +- enable-gpios: GPIO specifier, used to enable/disable the BT module
> +- reset-gpios: GPIO specifier, used to reset the BT module
> +
> +
> +Example:
> +
> +&uart {
> +	...
> +
> +	bluetooth {
> +		compatible = "realtek,rtl8723bs-bluetooth";
> +		enable-gpios = <&gpio 20 GPIO_ACTIVE_HIGH>;
> +		reset-gpios = <&gpio 11 GPIO_ACTIVE_HIGH>;
> +		realtek,config-data = /bits/ 8 <
> +			0x55 0xab 0x23 0x87 0x29 0x00 0xf4 0x00 0x01 0x01 0xf6 0x00
> +			0x02 0x81 0x00 0xfa 0x00 0x02 0x12 0x80 0x0c 0x00 0x10 0x02
> +			0x80 0x92 0x04 0x50 0xc5 0xea 0x19 0xe1 0x1b 0xfd 0xaf 0x5f
> +			0x01 0xa4 0x0b 0xd9 0x00 0x01 0x0f 0xe4 0x00 0x01 0x08>;
> +	};
> +};

Regards

Marcel