[PATCH 2/2] net: stmmac: dwmac-meson: extend phy mode setting
Yixun Lan
yixun.lan at amlogic.com
Thu Apr 26 20:09:59 PDT 2018
Hi Jerome
On 04/26/18 16:47, Jerome Brunet wrote:
> On Thu, 2018-04-26 at 16:05 +0000, Yixun Lan wrote:
>> In the Meson-AXG SoC, the phy mode setting of PRG_ETH0 in the glue layer
>> is extended from bit[0] to bit[2:0].
>> There is no problem if we configure it to the RGMII 1000M PHY mode,
>> since the register setting is coincidentally compatible with previous one,
>> but for the RMII 100M PHY mode, the configuration need to be changed to
>> value - b100.
>> This patch was verified with a RTL8201F 100M ethernet PHY.
>>
>> Signed-off-by: Yixun Lan <yixun.lan at amlogic.com>
>> ---
>> .../ethernet/stmicro/stmmac/dwmac-meson8b.c | 95 ++++++++++++++++---
>> 1 file changed, 84 insertions(+), 11 deletions(-)
>>
>> diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
>> index 7cb794094a70..e3688b6dd87c 100644
>> --- a/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
>> +++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
>> @@ -18,6 +18,7 @@
>> #include <linux/io.h>
>> #include <linux/ioport.h>
>> #include <linux/module.h>
>> +#include <linux/of_device.h>
>> #include <linux/of_net.h>
>> #include <linux/mfd/syscon.h>
>> #include <linux/platform_device.h>
>> @@ -29,6 +30,10 @@
>>
>> #define PRG_ETH0_RGMII_MODE BIT(0)
>>
>> +#define PRG_ETH0_EXT_PHY_MODE_MASK GENMASK(2, 0)
>> +#define PRG_ETH0_EXT_RGMII_MODE 1
>> +#define PRG_ETH0_EXT_RMII_MODE 4
>> +
>> /* mux to choose between fclk_div2 (bit unset) and mpll2 (bit set) */
>> #define PRG_ETH0_CLK_M250_SEL_SHIFT 4
>> #define PRG_ETH0_CLK_M250_SEL_MASK GENMASK(4, 4)
>> @@ -46,10 +51,16 @@
>> #define PRG_ETH0_TX_AND_PHY_REF_CLK BIT(12)
>>
>> #define MUX_CLK_NUM_PARENTS 2
>> +struct meson8b_dwmac_data {
>> + bool ext_phy_mode;
>> +};
>>
>> struct meson8b_dwmac {
>> struct device *dev;
>> void __iomem *regs;
>> +
>> + const struct meson8b_dwmac_data *data;
>> +
>> phy_interface_t phy_mode;
>> struct clk *rgmii_tx_clk;
>> u32 tx_delay_ns;
>> @@ -171,6 +182,46 @@ static int meson8b_init_rgmii_tx_clk(struct meson8b_dwmac *dwmac)
>> return 0;
>> }
>>
>> +static int meson8b_init_set_mode(struct meson8b_dwmac *dwmac)
>> +{
>> + bool ext_phy_mode = dwmac->data->ext_phy_mode;
>> +
>> + switch (dwmac->phy_mode) {
>> + case PHY_INTERFACE_MODE_RGMII:
>> + case PHY_INTERFACE_MODE_RGMII_RXID:
>> + case PHY_INTERFACE_MODE_RGMII_ID:
>> + case PHY_INTERFACE_MODE_RGMII_TXID:
>> + /* enable RGMII mode */
>> + if (ext_phy_mode)
>
> Looks weird to have this if target at a specific SoC withing a function named
> after another SoC
>
> Couldn't you make one function per soc type, and pass that function pointer in
> the match data ?
>
sounds good, I can do this
>> + meson8b_dwmac_mask_bits(dwmac, PRG_ETH0,
>> + PRG_ETH0_EXT_PHY_MODE_MASK,
>> + PRG_ETH0_EXT_RGMII_MODE);
>> + else
>> + meson8b_dwmac_mask_bits(dwmac, PRG_ETH0,
>> + PRG_ETH0_RGMII_MODE,
>> + PRG_ETH0_RGMII_MODE);
>> +
>> + break;
>> + case PHY_INTERFACE_MODE_RMII:
>> + /* disable RGMII mode -> enables RMII mode */
>> + if (ext_phy_mode)
>> + meson8b_dwmac_mask_bits(dwmac, PRG_ETH0,
>> + PRG_ETH0_EXT_PHY_MODE_MASK,
>> + PRG_ETH0_EXT_RMII_MODE);
>> + else
>> + meson8b_dwmac_mask_bits(dwmac, PRG_ETH0,
>> + PRG_ETH0_RGMII_MODE, 0);
>> +
>> + break;
>> + default:
>> + dev_err(dwmac->dev, "fail to set phy-mode %s\n",
>> + phy_modes(dwmac->phy_mode));
>> + return -EINVAL;
>> + }
>> +
>> + return 0;
>> +}
>> +
>> static int meson8b_init_prg_eth(struct meson8b_dwmac *dwmac)
>> {
>> int ret;
>> @@ -188,10 +239,6 @@ static int meson8b_init_prg_eth(struct meson8b_dwmac *dwmac)
>>
>> case PHY_INTERFACE_MODE_RGMII_ID:
>> case PHY_INTERFACE_MODE_RGMII_TXID:
>> - /* enable RGMII mode */
>> - meson8b_dwmac_mask_bits(dwmac, PRG_ETH0, PRG_ETH0_RGMII_MODE,
>> - PRG_ETH0_RGMII_MODE);
>> -
>> /* only relevant for RMII mode -> disable in RGMII mode */
>> meson8b_dwmac_mask_bits(dwmac, PRG_ETH0,
>> PRG_ETH0_INVERTED_RMII_CLK, 0);
>> @@ -224,10 +271,6 @@ static int meson8b_init_prg_eth(struct meson8b_dwmac *dwmac)
>> break;
>>
>> case PHY_INTERFACE_MODE_RMII:
>> - /* disable RGMII mode -> enables RMII mode */
>> - meson8b_dwmac_mask_bits(dwmac, PRG_ETH0, PRG_ETH0_RGMII_MODE,
>> - 0);
>> -
>> /* invert internal clk_rmii_i to generate 25/2.5 tx_rx_clk */
>> meson8b_dwmac_mask_bits(dwmac, PRG_ETH0,
>> PRG_ETH0_INVERTED_RMII_CLK,
>> @@ -274,6 +317,11 @@ static int meson8b_dwmac_probe(struct platform_device *pdev)
>> goto err_remove_config_dt;
>> }
>>
>> + dwmac->data = (const struct meson8b_dwmac_data *)
>> + of_device_get_match_data(&pdev->dev);
>> + if (!dwmac->data)
>> + return -EINVAL;
>> +
>> res = platform_get_resource(pdev, IORESOURCE_MEM, 1);
>> dwmac->regs = devm_ioremap_resource(&pdev->dev, res);
>> if (IS_ERR(dwmac->regs)) {
>> @@ -298,6 +346,10 @@ static int meson8b_dwmac_probe(struct platform_device *pdev)
>> if (ret)
>> goto err_remove_config_dt;
>>
>> + ret = meson8b_init_set_mode(dwmac);
>> + if (ret)
>> + goto err_remove_config_dt;
>> +
>> ret = meson8b_init_prg_eth(dwmac);
>> if (ret)
>> goto err_remove_config_dt;
>> @@ -316,10 +368,31 @@ static int meson8b_dwmac_probe(struct platform_device *pdev)
>> return ret;
>> }
>>
>> +static const struct meson8b_dwmac_data meson8b_dwmac_data = {
>> + .ext_phy_mode = false,
>> +};
>> +
>> +static const struct meson8b_dwmac_data meson_axg_dwmac_data = {
>> + .ext_phy_mode = true,
>> +};
>> +
>> static const struct of_device_id meson8b_dwmac_match[] = {
>> - { .compatible = "amlogic,meson8b-dwmac" },
>> - { .compatible = "amlogic,meson8m2-dwmac" },
>> - { .compatible = "amlogic,meson-gxbb-dwmac" },
>> + {
>> + .compatible = "amlogic,meson8b-dwmac",
>> + .data = &meson8b_dwmac_data,
>> + },
>> + {
>> + .compatible = "amlogic,meson8m2-dwmac",
>> + .data = &meson8b_dwmac_data,
>> + },
>> + {
>> + .compatible = "amlogic,meson-gxbb-dwmac",
>> + .data = &meson8b_dwmac_data,
>> + },
>> + {
>> + .compatible = "amlogic,meson-axg-dwmac",
>> + .data = &meson_axg_dwmac_data,
>> + },
>> { }
>> };
>> MODULE_DEVICE_TABLE(of, meson8b_dwmac_match);
>
> .
>
More information about the linux-amlogic
mailing list