Testing.

[Oleg]

[    5.784393] tegra-ehci: Tegra EHCI driver
[    5.788381] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
[    5.794471] ohci-pci: OHCI PCI platform driver
[    5.798903] ohci-platform: OHCI generic platform driver
[    5.804174] ohci-omap3: OHCI OMAP3 driver
[    5.808132] SPEAr-ohci: OHCI SPEAr driver
[    5.812119] ohci-st: OHCI STMicroelectronics driver
[    5.816989] ohci-atmel: OHCI Atmel driver
[    5.821290] usbcore: registered new interface driver usb-storage
[    5.829289] i2c /dev entries driver
[    5.835640] meson_wdt c1109900.watchdog: Watchdog enabled (timeout=8 
sec, nowayout=0)
[    5.839928] sdhci: Secure Digital Host Controller Interface driver
[    5.844316] sdhci: Copyright(c) Pierre Ossman
[    5.849477] Synopsys Designware Multimedia Card Interface Driver
[    5.856562] sdhci-pltfm: SDHCI platform and OF driver helper
[    5.861442] of_pwm_get(): PWM chip not found
[    5.864538] leds_pwm pwmleds: unable to request PWM for 
m8s:blue:power: -517
[    5.871728] ledtrig-cpu: registered to indicate activity on CPUs
[    5.877766] usbcore: registered new interface driver usbhid
[    5.883048] usbhid: USB HID core driver
[    5.944209] NET: Registered protocol family 10
[    5.944923] Segment Routing with IPv6
[    5.946713] sit: IPv6, IPv4 and MPLS over IPv4 tunneling driver
[    5.953100] NET: Registered protocol family 17
[    5.956991] can: controller area network core (rev 20120528 abi 9)
[    5.963199] NET: Registered protocol family 29
[    5.967561] can: raw protocol (rev 20120528)
[    5.971808] can: broadcast manager protocol (rev 20161123 t)
[    5.977457] can: netlink gateway (rev 20130117) max_hops=1
[    5.983198] Key type dns_resolver registered
[    5.987424] ThumbEE CPU extension supported.
[    5.991403] Registering SWP/SWPB emulation handler
[    5.997855] Btrfs loaded, crc32c=crc32c-generic
[    6.005513] dwc2 c9040000.usb: c9040000.usb supply vusb_d not found, 
using dummy regulator
[    6.008952] dwc2 c9040000.usb: c9040000.usb supply vusb_a not found, 
using dummy regulator
[    6.018320] phy phy-c1108800.phy.0: USB ID detect failed!
[    6.022538] phy phy-c1108800.phy.0: phy poweron failed --> -22
[    6.028450] dwc2: probe of c9040000.usb failed with error -22
[    6.035485] dwc2 c90c0000.usb: c90c0000.usb supply vusb_d not found, 
using dummy regulator
[    6.042337] dwc2 c90c0000.usb: c90c0000.usb supply vusb_a not found, 
using dummy regulator
[    6.182662] dwc2 c90c0000.usb: DWC OTG Controller
[    6.182732] dwc2 c90c0000.usb: new USB bus registered, assigned bus 
number 1
[    6.188786] dwc2 c90c0000.usb: irq 23, io mem 0xc90c0000
[    6.194739] hub 1-0:1.0: USB hub found
[    6.197804] hub 1-0:1.0: 1 port detected
[    6.206952] of_pwm_get(): PWM chip not found
[    6.207005] leds_pwm pwmleds: unable to request PWM for 
m8s:blue:power: -517
[    6.213401] hctosys: unable to open rtc device (rtc0)
[    6.218262] VCC3V3: disabling
[    6.222866] Freeing unused kernel memory: 2048K
[    6.622590] usb 1-1: new high-speed USB device number 2 using dwc2
[    6.832594] usb 1-1: device descriptor read/64, error -32
[    7.162580] usb 1-1: device descriptor read/64, error -32
[    7.492542] usb 1-1: new high-speed USB device number 3 using dwc2
[    7.702535] usb 1-1: device descriptor read/64, error -32
[    8.032534] usb 1-1: device descriptor read/64, error -32
[    8.362547] usb 1-1: new high-speed USB device number 4 using dwc2
[    8.802534] usb 1-1: device not accepting address 4, error -32
[    9.012535] usb 1-1: new high-speed USB device number 5 using dwc2
[    9.452534] usb 1-1: device not accepting address 5, error -32
[    9.452767] usb usb1-port1: unable to enumerate USB device
[  133.312550] random: crng init done