[PATCH net] mdio: mux: fix parsing mux registers outside of the PHY address range

[Martin Blumenstingl]

mdio_mux_init parses the child nodes of the MDIO mux. When using
"mdio-mux-mmioreg" the child nodes are describing the register value
that is written to switch between the MDIO busses.

The change which makes the error messages more verbose changed the
parsing of the "reg" property from a simple of_property_read_u32 call
to of_mdio_parse_addr. On a Khadas VIM (based on the Meson GXL SoC,
which uses mdio-mux-mmioreg) this prevents registering the MDIO mux
(because the "reg" values on the MDIO mux child nodes are 0x2009087f
and 0xe40908ff) and leads to the following errors:
  mdio-mux-mmioreg c883455c.eth-phy-mux: /soc/periphs at c8834000/eth-phy-mux/mdio at e40908ff PHY address -469169921 is too large
  mdio-mux-mmioreg c883455c.eth-phy-mux: Error: Failed to find reg for child /soc/periphs at c8834000/eth-phy-mux/mdio at e40908ff
  mdio-mux-mmioreg c883455c.eth-phy-mux: /soc/periphs at c8834000/eth-phy-mux/mdio at 2009087f PHY address 537462911 is too large
  mdio-mux-mmioreg c883455c.eth-phy-mux: Error: Failed to find reg for child /soc/periphs at c8834000/eth-phy-mux/mdio at 2009087f
  mdio-mux-mmioreg c883455c.eth-phy-mux: Error: No acceptable child buses found
  mdio-mux-mmioreg c883455c.eth-phy-mux: failed to register mdio-mux bus /soc/periphs at c8834000/eth-phy-mux
(as a result of that ethernet is not working, because the PHY which is
connected through the mux' child MDIO bus, which is not being
registered).

Fix this by reverting the change from of_mdio_parse_addr to
of_mdio_parse_addr.

Fixes: 342fa1964439 ("mdio: mux: make child bus walking more permissive and errors more verbose")
Signed-off-by: Martin Blumenstingl <martin.blumenstingl at googlemail.com>
---
 drivers/net/phy/mdio-mux.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/phy/mdio-mux.c b/drivers/net/phy/mdio-mux.c
index 00755b6a42cf..c608e1dfaf09 100644
--- a/drivers/net/phy/mdio-mux.c
+++ b/drivers/net/phy/mdio-mux.c
@@ -135,8 +135,8 @@ int mdio_mux_init(struct device *dev,
 	for_each_available_child_of_node(dev->of_node, child_bus_node) {
 		int v;
 
-		v = of_mdio_parse_addr(dev, child_bus_node);
-		if (v < 0) {
+		r = of_property_read_u32(child_bus_node, "reg", &v);
+		if (r) {
 			dev_err(dev,
 				"Error: Failed to find reg for child %s\n",
 				of_node_full_name(child_bus_node));
-- 
2.13.2