[PATCH 1/7] clk: gxbb: expose USB clocks
khilman at baylibre.com
Wed Sep 7 19:24:50 PDT 2016
On Wed, Sep 7, 2016 at 3:14 PM, Stephen Boyd <sboyd at codeaurora.org> wrote:
> On 09/07, Martin Blumenstingl wrote:
>> On Wed, Sep 7, 2016 at 2:33 AM, Stephen Boyd <sboyd at codeaurora.org> wrote:
>> > On 09/04, Martin Blumenstingl wrote:
>> >> USB0_DDR_BRIDGE and USB1_DDR_BRIDGE1 are needed for the related
>> >> dwc2 usb controller. USB, USB0 and USB1 are needed for the PHYs.
>> >> Expose these clocks to DT and comment out in clk driver.
>> >> Signed-off-by: Jerome Brunet <jbrunet at baylibre.com>
>> >> Signed-off-by: Martin Blumenstingl <martin.blumenstingl at googlemail.com>
>> > Is authorship correct on this patch? Did Jerome author it
>> > instead?
>> We (Jerome and I) have both worked on this patch, that's why you have
>> two signed-off-by's.
>> Or is this simply about the order (author = from address should be
>> listed first)?
> Yes. Typically author is listed first in the signed-off-by chain.
And if you use git-format-patch + git-send-email, there would also be a
From: Jerome Brunet <jbrunet at baylibre.com>
at the beginning so that when it gets applied by the maintainer,
authorship is correct.
More information about the linux-amlogic