[PATCH v5 0/6] Add Meson 8b / GXBB support to the IR driver
Martin Blumenstingl
martin.blumenstingl at googlemail.com
Sat Aug 20 02:53:23 PDT 2016
Newer Amlogic platforms (Meson 8b and GXBB) use a slightly different
register layout for their Infrared Remoete Controller. The decoder mode
is now configured in another register. Without the changes to the
meson-ir driver we are simply getting incorrect "durations" reported
from the hardware (because the hardware is not in time measurement aka
software decode mode).
This problem was also noticed by some people trying to use this on an
ODROID-C1 and ODROID-C2 - the workaround there (probably because the
datasheets were not publicy available yet at that time) was to switch
to ir_raw_event_store_edge (which leaves it up to the kernel to measure
the duration of a pulse). See [0] and [1] for the corresponding
patches.
Changes in v5:
- changed pin function and group names to remote_input_ao so they match
with the datasheet
Tested-by: Neil Armstrong <narmstrong at baylibre.com>
[0] https://github.com/erdoukki/linux-amlogic-1/commit/969b2e2242fb14a13cb651f9a1cf771b599c958b
[1] http://forum.odroid.com/viewtopic.php?f=135&t=20504
Martin Blumenstingl (3):
pinctrl: amlogic: gxbb: add the IR remote input pin
ARM64: dts: amlogic: add the input pin for the IR remote
ARM64: dts: meson-gxbb: Enable the the IR decoder on supported boards
Neil Armstrong (3):
dt-bindings: media: meson-ir: Add Meson8b and GXBB compatible strings
media: rc: meson-ir: Add support for newer versions of the IR decoder
ARM64: dts: meson-gxbb: Add Infrared Remote Controller decoder
.../devicetree/bindings/media/meson-ir.txt | 5 +++-
.../arm64/boot/dts/amlogic/meson-gxbb-odroidc2.dts | 6 +++++
arch/arm64/boot/dts/amlogic/meson-gxbb-p20x.dtsi | 6 +++++
.../boot/dts/amlogic/meson-gxbb-vega-s95.dtsi | 6 +++++
arch/arm64/boot/dts/amlogic/meson-gxbb.dtsi | 14 +++++++++++
drivers/media/rc/meson-ir.c | 29 ++++++++++++++++++----
drivers/pinctrl/meson/pinctrl-meson-gxbb.c | 8 ++++++
7 files changed, 68 insertions(+), 6 deletions(-)
--
2.9.3
More information about the linux-amlogic
mailing list