[PATCH v5 10/10] arm64: dts: actions: Add uSD support for Cubieboard7

[Manivannan Sadhasivam]

On Mon, Jul 13, 2020 at 02:38:55PM +0530, Amit Tomer wrote:
> Hi,
> 
> > Fixed regulators are used to nicely model the regulators which aren't tied to
> > any PMIC. But for some cases we use them to represent supplies when there is
> > no support for the specific PMIC present in the kernel and they are turned
> > on/configured by the bootloader (this is what happening here).
> >
> > And there is no use of declaring fixed regulators when there is no consumer.
> > Even if you don't define these, the corresponding supplies in the board will
> > always be in the same state configured by the bootloader. So I'd suggest you
> > to remove this for now.
> 
> Checked the schematics and regulator name is the same for both eMMC and uSD

Okay, fine.

> Shall we keep uSD regulator sd_vcc to be consistent across ACTIONS platform?
> 

No. As I said before it depends on the individual board schematics.

Thanks,
Mani

> > Since I don't have the schematics to check, please make sure you name the
> > regulators as mentioned in the schematics (this could vary from board to board,
> > so don't just copy from others).
> >
> 
> Sure, point noted.
> 
> Thanks
> -Amit.