libertas_sdio doesn't work after reloading

[Andrey Yurovsky]

Hi Matt.  Is this on an embedded system or on a desktop PC with some
host controller?  If so, which one?  I'm curious because module reload
seems to work fine with my Ricoh host controller.

  -Andrey

On Mon, Feb 2, 2009 at 1:31 PM, Matt Reimer <mreimer at sdgsystems.com> wrote:
> For some reason the libertas_sdio driver works the first time it is
> loaded, but not after subsequent reloads. What is the proper fix for
> this problem?
>
> I experimented with trying to send CMD_802_11_RESET but to no effect.
> For now I'm using a nasty hack that simulates a card insertion/removal
> on load/unload, but at least it works.
>
> Perhaps when the card resets, it also resets the SDIO communication
> parameters (probably back to 1-bit, etc.) but the stack is still
> running the clock fast, in wide mode? I see there's a function
> sdio_reset_comm(), but it's unused.
>
> Here's a previous discussion on this problem:
> "rmmod libertas_sdio and reinsert causes problems with firmware upload"
> http://lists.infradead.org/pipermail/libertas-dev/2008-September/001928.html
>
> What would be the best way to proceed?
>
> Matt
>
> _______________________________________________
> libertas-dev mailing list
> libertas-dev at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/libertas-dev
>