sdio 8686 firmware load problem.

[Jonathan Cameron]

V8 and V9 firmware's from git repository are both giving the following debug.

libertas enter: lbs_init_module()
libertas leave: lbs_init_module()
libertas enter: if_sdio_init_module()
libertas_sdio: Libertas SDIO driver
libertas_sdio: Copyright Pierre Ossman
libertas enter: if_sdio_probe()
libertas sdio: class = 0x7, vendor = 0x2DF, device = 0x9103, model = 0xB, ioport = 0x10000
libertas enter: if_sdio_prog_firmware()
libertas sdio: firmware status = 0x0
into sdio firmware load
libertas enter: if_sdio_prog_helper()
libertas_sdio mmc0:0001:1: firmware: requesting sd8686_helper.bin
libertas sdio: waiting for helper to boot...
libertas leave: if_sdio_prog_helper(), ret 0
libertas enter: if_sdio_prog_real()
libertas_sdio mmc0:0001:1: firmware: requesting sd8686.bin
libertas sdio: firmware wants 16 bytes
libertas sdio: firmware wants 17 bytes
libertas sdio: firmware helper signalled error
libertas: failed to load firmware
libertas leave: if_sdio_prog_real(), ret -5
libertas leave: if_sdio_prog_firmware(), ret -5
libertas leave: if_sdio_probe(), ret -5
libertas_sdio: probe of mmc0:0001:1 failed with error -5
libertas leave: if_sdio_init_module(), ret 0

This was previously working with this board and the same kernel setup
prior to switching from a scratch built filesystem etc to using openembedded.

Anyone have any suggestions on what might be happening?

Thanks,

Jonathan