[LEDE-DEV] SUNXI: Network problem with kernel 4.9.51

[Lucian Cristian]

On 27.09.2017 23:32, Hauke Mehrtens wrote:
> On 09/27/2017 10:05 PM, Lucian Cristian wrote:
>>> Do you have a crash log?
>>>
>>> I would like to add this to master soon, because it adds ssupport for
>>> the mac found on some recent Allwinner SoCs.
>>>
>>> Hauke
>>>
>>> _______________________________________________
>>> Lede-dev mailing list
>>> Lede-dev at lists.infradead.org
>>> http://lists.infradead.org/mailman/listinfo/lede-dev
>> attached, but I'll try with a clean tree later
>>
>> Regards
> Thank you,
>
> I pushed a change to my sunxi branch, can you try again.
>
> Hauke
>
> _______________________________________________
> Lede-dev mailing list
> Lede-dev at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/lede-dev

is working

[    1.074837] sun7i-dwmac 1c50000.ethernet: PTP uses main clock
[    1.080592] sun7i-dwmac 1c50000.ethernet: no reset control found
[    1.086721] sun7i-dwmac 1c50000.ethernet: no regulator found
[    1.092471] sun7i-dwmac 1c50000.ethernet: Ring mode enabled
[    1.098043] sun7i-dwmac 1c50000.ethernet: DMA HW capability register 
supported
[    1.105287] sun7i-dwmac 1c50000.ethernet: Normal descriptors
[    1.118823] libphy: stmmac: probed
[    1.122283] sun7i-dwmac 1c50000.ethernet (unnamed net_device) 
(uninitialized): PHY ID 001cc912 at 1 IRQ POLL (stmmac-0:01) active

[  148.217343] Generic PHY stmmac-0:01: attached PHY driver [Generic 
PHY] (mii_bus:phy_addr=stmmac-0:01, irq=-1)
[  148.229289] sun7i-dwmac 1c50000.ethernet eth0: RX IPC Checksum 
Offload disabled
[  148.236956] sun7i-dwmac 1c50000.ethernet eth0: No MAC Management 
Counters available
[  148.245902] sun7i-dwmac 1c50000.ethernet eth0: PTP not supported by HW
[  148.253979] br-lan: port 1(eth0) entered blocking state
[  148.259214] br-lan: port 1(eth0) entered disabled state
[  148.265064] device eth0 entered promiscuous mode
[  148.275298] IPv6: ADDRCONF(NETDEV_UP): br-lan: link is not ready
[  152.391695] sun7i-dwmac 1c50000.ethernet eth0: Link is Up - 
1Gbps/Full - flow control off

Regards