[LEDE-DEV] [PATCH v3] ramips: add support for GL-inet GL-MT300N-V2

[Mathias Kresin]

2017-05-17 12:18 GMT+02:00 kysonlok <kysonlok at gmail.com>:
> This patch adds supports for the GL-inet GL-MT300N-V2.
>
> Specification:
> - SoC: MediaTek MT7628AN
> - Flash: 16 MiB (W25Q128FVSG)
> - RAM: 128 MiB DDR
> - Ethernet: 1 x WAN (100 Mbps) and 1 x LAN (100 Mbps)
> - USB: 1 x USB 2.0 port
> - Button: 1 x switch button, 1 x reset button
> - LED: 3 x LEDS (system power led is not GPIO controller)
> - UART: 1 x UART on PCB (JP1: 3.3V, RX, TX, GND)
>
> Installation through Luci:
> - The original firmware is LEDE, so both LuCI or sysupgrade can be used.
> - Do not keep settings, for sysupgrade please use the -n option.
>
> Installation through bootloader webserver:
> - Plug power and hold reset button until red LED blink to bright.
> - Install sysupgrade image using web interface on 192.168.1.1.
>
> Signed-off-by: kyson Lok <kysonlok at gmail.com>
> ---
>  target/linux/ramips/base-files/etc/board.d/01_leds |   3 +
>  .../linux/ramips/base-files/etc/board.d/02_network |   4 +
>  target/linux/ramips/base-files/etc/diag.sh         |   3 +
>  target/linux/ramips/base-files/lib/ramips.sh       |   3 +
>  .../ramips/base-files/lib/upgrade/platform.sh      |   1 +
>  target/linux/ramips/dts/GL-MT300N-V2.dts           | 133 +++++++++++++++++++++
>  target/linux/ramips/image/mt7628.mk                |   8 ++
>  7 files changed, 155 insertions(+)
>  create mode 100644 target/linux/ramips/dts/GL-MT300N-V2.dts

Merged to my staging tree with a little bugfix. Will push it to master
during the next days.

Thanks!