[LEDE-DEV] dnsmasq make DHCPv6 viable for standalone dnsmasq install
ericluehrsen at hotmail.com
Fri Feb 3 13:46:48 PST 2017
I will look at it this weekend. It seems that maybe some intermediate
rebase-to-trunk event chewed up a line of code. The commit was lingering
for quite a while. There is a report for another issue also. Its
probably an esay fix, just need to stare at it for a while.
-------- Original message --------
From: Daniel Petre <daniel.petre at gavana3.ro>
Date: 2/3/17 05:26 (GMT-05:00)
To: Eric Luehrsen <ericluehrsen at hotmail.com>, Jo-Philipp Wich <jo at mein.io>
Subject: Re: dnsmasq: make DHCPv6 viable for standalone dnsmasq install
On 02/02/2017 07:52 PM, Eric Luehrsen wrote:
> What I submitted I had tested on TL WDR3600 and TL Archer C7 ... working
> together. The archer DHCP-PD with odhcpd to the Wdr with dnsmasq full.
I only tried the dnsmasq-dhcpv6 and dnsmasq-full with only IPv6
selected. Should i compile in all dnsmasq options?
> Also pulled from. JOW staging at some point to see ... but I may not
> have tested any last minute fixup work.
> - Eric
> -------- Original message --------
> From: Daniel Petre <daniel.petre at gavana3.ro>
> Date: 2/2/17 10:55 (GMT-05:00)
> To: Eric Luehrsen <ericluehrsen at hotmail.com>, Jo-Philipp Wich <jo at mein.io>
> Subject: dnsmasq: make DHCPv6 viable for standalone dnsmasq install
> are you sure your commit works..? Did you tested it?
> I have just removed odhcpd and tried both dnsmasq-dhcpv6 and the full
> dnsmasq with ipv6 enabled without luck. No IPv6 is getting to my wifi
> laptop from a nexx wt3020 router while the setup with odhcpd works just
> I have a /64 via PD on pppoe.
More information about the Lede-dev