[LEDE-DEV] [RFC] mvebu: simplify etc/board.d/02_network

[p.wassi at gmx.at]

From: Paul Wassi <p.wassi at gmx.at>

Unify switch configuration on Linksys WRTxx00AC series.
LAN = eth0, WAN = eth1

Signed-off-by: Paul Wassi <p.wassi at gmx.at>
---
In the OpenWrt wiki, it can be seen that the Linksys WRTxx00AC series
has a device dependent switch configuration:
https://wiki.openwrt.org/toh/linksys/wrt_ac_series#switch_layout
All devices have eth0 and eth1, however some devices set eth0 as LAN, eth1 as WAN,
while others do it the other way 'round: eth0 = WAN, eth1 = LAN.
As I don't see a technical requirement to have these differences, couldn't we
make life (and code) easier by unifying switch configuration among these devices.
I.e. the WRTxx00AC series would then have eth0 = LAN, eth1 = WAN and therefore share
the same lines of code (for network configuration).

 linux/mvebu/base-files/etc/board.d/02_network |    6 +-----
 1 file changed, 1 insertion(+), 5 deletions(-)

diff --git a/target/linux/mvebu/base-files/etc/board.d/02_network b/target/linux/mvebu/base-files/etc/board.d/02_network
--- a/target/linux/mvebu/base-files/etc/board.d/02_network
+++ b/target/linux/mvebu/base-files/etc/board.d/02_network
@@ -15,11 +15,7 @@ case "$board" in
 armada-385-linksys-caiman|\
 armada-385-linksys-cobra|\
 armada-385-linksys-rango|\
-armada-385-linksys-shelby)
-	ucidef_set_interfaces_lan_wan "eth1" "eth0"
-	ucidef_add_switch "switch0" \
-		"0:lan:4" "1:lan:3" "2:lan:2" "3:lan:1" "6 at eth1" "4:wan" "5 at eth0"
-	;;
+armada-385-linksys-shelby|\
 armada-xp-linksys-mamba)
 	ucidef_set_interfaces_lan_wan "eth0" "eth1"
 	ucidef_add_switch "switch0" \