[LEDE-DEV] [RFC] ADSL Modem Allnet All0333CJ Rev.C / Amazon-SE SoC

[Tino Reichardt]

* Mathias Kresin <dev at kresin.me> wrote:
> 2016-11-04 9:46 GMT+01:00 Tino Reichardt <list-lede at mcmilk.de>:
> > * Alberto Bursi <alberto.bursi at outlook.it> wrote:
> >> On 11/03/2016 10:13 AM, Tino Reichardt wrote:
> >> > Most of these Modems have only a very small flash of 2MB or 4MB .. so
> >> > there is no need for lot of stuff. My aim is to have nice DSL modems
> >> > with recent kernel and dsl firmware. pppoe is not really needed, but
> >> > will fit also into that flash, I think.
> >> >
> >>
> > ## Booting image at 80100000 ...
> >    Image Name:   MIPS LEDE Linux-4.4.30
> >    Created:      2016-11-03   7:34:38 UTC
> >    Image Type:   MIPS Linux Kernel Image (lzma compressed)
> >    Data Size:    1358940 Bytes =  1.3 MB
> >    Load Address: 80002000
> >    Entry Point:  80002000
> >    Verifying Checksum ... OK
> >    Uncompressing Kernel Image ... ERROR: LzmaDecode.c, 561
> >
> > Decoding error = 1
> > LZMA ERROR 1 - must RESET board to recover
> 
> Not sure what the root cause of the error is, but I've two possible
> workarounds in mind. You can try to tftp the kernel to memory address
> 0x81000000:
> 
>   tftp 0x81000000 uImage; bootm 0x81000000

This hint was right, I tried 0x802000000, but then give up on this...
I think, 0x81000000 (16MB) is to high, my dev has only 16MB ;)

But I used 6MB and now it boots. These commands are nedded:
# tftpboot 0x80600000
# bootm 0x80600000 does it.


-- 
Best regards, TR