[LEDE-DEV] skb_warn_bad_offload + crash at high load on ipq806x

[A. Benz]

Great find

The observation below is no longer relevant, but after the eth0 report 
in your earlier email I adjusted my network as follows:


config interface 'lan'
         option ifname 'eth1.1'

config interface 'wan'
         option ifname 'eth1.200'

config switch
         option name 'switch0'
         option reset '1'
         option enable_vlan '1'

config switch_vlan
         option device 'switch0'
         option vlan '1'
         option ports '1 2 3 4 6t'

config switch_vlan
         option device 'switch0'
         option vlan '2'
         option vid '200'
         option ports '5t 6t'

It dialed to ISP right away, and been very stable. I tried reproducing 
what would normally crash the router but its stable.

I was expecting to assign one of the LAN ports to WAN, but the physical 
WAN port was still usable.. I found that strange.

Regards,
A. Benz

On 06/18/16 18:49, Josh Bendavid wrote:
> This is resolved by https://github.com/lede-project/source/pull/134
> for the record.
>
> _______________________________________________
> Lede-dev mailing list
> Lede-dev at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/lede-dev
>