[LEDE-DEV] skb_warn_bad_offload + crash at high load on ipq806x

Josh Bendavid joshbendavid at gmail.com
Fri Jun 17 12:42:24 PDT 2016


Further update in case anyone has any ideas.

The C2600 device on which I'm testing has two ethernet adapters with
their own dedicated connection to the switch, with the default config
such that eth0 is WAN and eth1 is LAN, configured with untagged vlans
on the switch.

I've tried two alternate configurations
1) Using eth0 only as LAN and WAN using vlan tagging as on platforms
with only one ethernet interface+switch connection
2) Same as above, but using only eth1

Configuration 1) leads to similar results as the default with both
interfaces.  Configuration 2) seems rock solid.  (But will continue to
push it a bit longer.)

So it sounds like there's something not right about the
configuration/initialization of eth0 on this platform.

Since the ap148 and netgear R7500/D7800 are configured in the same
way, it might be useful if someone with one of those can try to
reproduce.

There was also some strange ethernet behaviour on the Linksys EA8500
which Adrian and I were discussing in
https://github.com/lede-project/source/pull/6 which may turn out to be
related.

Thanks,
Josh



More information about the Lede-dev mailing list