[LEDE-DEV] sysupgrade on lantiq xrx200 form openwrt to lede

[Syrone Wong]

Hi,

You may want to flash back to factory and flash to LEDE via
*-factory.bin. Make sure to set all configurations by hand.
Best Regards,
Syrone Wong


On Thu, Jul 14, 2016 at 8:48 PM, Florian Eckert
<eckert.florian at googlemail.com> wrote:
> Hello LEDE-Team
>
> I am using a openwrt 15.05 on an lantiq xrx200 device.
> Upgrade works always as expectet for 15.05.
> I am using the squashfs tar file.
>
> I wantet to test lede and i have seen that the image generation has
> completly changed there is no tar file anymore only bin.
> If i use this to make a sysupgrade command i always get the output
>
> Could not open mtd device: firmware
> Can't open device for writing!
> Upgrade completed
> Rebooting system...
>
> In openwrt i always could untar the tar file. To see the structur CONTROL ...
> In lede this does not work anymore.
>
> What to i make wrong? Could you explain your changes?
>
> Regards Flo
>
> _______________________________________________
> Lede-dev mailing list
> Lede-dev at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/lede-dev