[LEDE-DEV] DHCP via bridge in case of IPv4

Alexey Brodkin Alexey.Brodkin at synopsys.com
Sun Jul 10 23:15:58 PDT 2016


Hi Russel,

On Sun, 2016-07-10 at 00:19 -0700, Russell Senior wrote:
> > 
> > > 
> > > > 
> > > > > 
> > > > > > 
> > > > > > "Alexey" == Alexey Brodkin <Alexey.Brodkin at synopsys.com> writes:
> Alexey> Hi Aaron,
> Alexey> On Sat, 2016-07-09 at 07:47 -0400, Aaron Z wrote:
> > 
> > > 
> > > On Sat, Jul 9, 2016 at 4:37 AM, Alexey Brodkin
> > > <Alexey.Brodkin at synopsys.com> wrote:
> > > > 
> > > > 
> > > > Hello,
> > > > 
> > > > I was playing with quite simple bridged setup on different boards
> > > with > very recent kernels (4.6.3 as of this writing) and found one
> > > interesting > behavior that I cannot yet understand and googling
> > > din't help here as well.
> > > > 
> > > > 
> > > > My setup is pretty simple: >
> > > -------------       ------------------       -------------------------
> > > > 
> > > > > 
> > > > > 
> > > > > HOST      |       | "Dumb AP"      |       | Wireless
> > > client       | > > with DHCP |<----->(eth0)     (wlan0)<----->|
> > > attempting to         | > > server    |       |    \ br0
> > > /     |       | get settings via DHCP | >
> > > -------------       ------------------       -------------------------
> > > > 
> > > > 
> > > > * HOST is my laptop with DHCP server that works for sure.  > *
> > > "Dumb AP" is a separate board (I tried ARM-based Wandboard and
> > > ARC-based >   AXS10x boards but results are exactly the same) with
> > > wired (eth0) and wireless >   (wlan0) network controllers bridged
> > > together (br0). That "br0" bridge flawlessly >   gets its settings
> > > from DHCP server on host.  > * Wireless client could be either a
> > > smatrphone or another laptop etc but >   what's important it should
> > > be configured to get network settings by DHCP as well.
> > > > 
> > > > 
> > > > So what happens "br0" always gets network settings from DHCP server
> > > on HOST.  > That's fine. But wireless client only reliably gets
> > > settings from DHCP server > if IPv6 is enabled on "Dumb AP" board. If
> > > IPv6 is disabled I may see that > wireless client sends "DHCP
> > > Discover" then server replies with "DHCP Offer" but > that offer
> > > never reaches wireless client.
> > > 
> > > 
> > > Do you have WDS enabled? If not, DHCP has issues in that scenario:
> > > https://wiki.openwrt.org/doc/howto/clientmode
> If the Dumb AP's wireless interface is in ap-mode, then this shouldn't
> be an issue.  It's only client-mode interfaces that have trouble with bridging.
> 
> I'd suggest running tcpdump on the Dumb AP's wireless interface and the
> client's wireless interface and see which of them sees the various parts
> of the DHCP handshake.

So I did but for DHCP server and wireless client (had no tcpdump on Dump AP
at the moment).

That's what I see on the server:
----------------------------->8-------------------------------
No. Time        Source     Destination      Protocol Length Info
 3 0.151181000  0.0.0.0    255.255.255.255  DHCP     342    DHCP Discover - Transaction ID 0x31dc321f
11 2.760796000  10.42.0.1  10.42.0.13       DHCP     342    DHCP Offer    - Transaction ID 0x31dc321f
14 5.220985000  0.0.0.0    255.255.255.255  DHCP     342    DHCP Discover - Transaction ID 0x31dc321f
15 5.221150000  10.42.0.1  10.42.0.13       DHCP     342    DHCP Offer    - Transaction ID 0x31dc321f
23 15.649835000 0.0.0.0    255.255.255.255  DHCP     342    DHCP Discover - Transaction ID 0x31dc321f
24 15.650017000 10.42.0.1  10.42.0.13       DHCP     342    DHCP Offer    - Transaction ID 0x31dc321f
32 25.648589000 0.0.0.0    255.255.255.255  DHCP     342    DHCP Discover - Transaction ID 0x31dc321f
33 25.648758000 10.42.0.1  10.42.0.13       DHCP     342    DHCP Offer    - Transaction ID 0x31dc321f
43 35.864567000 0.0.0.0    255.255.255.255  DHCP     342    DHCP Discover - Transaction ID 0x31dc321f
48 38.832837000 10.42.0.1  10.42.0.13       DHCP     342    DHCP Offer    - Transaction ID 0x31dc321f
----------------------------->8-------------------------------

That's on the wireless client:
----------------------------->8-------------------------------
No.  Time           Source   Destination      Protocol Length Info
1171 94.192971000   0.0.0.0  255.255.255.255  DHCP     342    DHCP Discover - Transaction ID 0x31dc321f
1182 99.263686000   0.0.0.0  255.255.255.255  DHCP     342    DHCP Discover - Transaction ID 0x31dc321f
1185 109.692642000  0.0.0.0  255.255.255.255  DHCP     342    DHCP Discover - Transaction ID 0x31dc321f
1186 119.691474000  0.0.0.0  255.255.255.255  DHCP     342    DHCP Discover - Transaction ID 0x31dc321f
1190 129.907507000  0.0.0.0  255.255.255.255  DHCP     342    DHCP Discover - Transaction ID 0x31dc321f
----------------------------->8-------------------------------

I'll try to capture data from Dumb AP sometime soon and will reply to the thread.

-Alexey


More information about the Lede-dev mailing list