[LEDE-DEV] [PATCH] lantiq: mac address setting on BTHOMEHUBV3A

[Ben Mulvihill]

Rename uboot environment partition on BT Home Hub 3A so that mac address 
setting works correctly.

Also, the mac address field in the ath9k calibration data is not used,
and should not be referenced in the dts.


Signed-off-by: Ben Mulvihill <ben.mulvihill at gmail.com>
---
diff -uprN a/target/linux/lantiq/dts/BTHOMEHUBV3A.dts b/target/linux/lantiq/dts/BTHOMEHUBV3A.dts
--- a/target/linux/lantiq/dts/BTHOMEHUBV3A.dts	2016-07-04 20:12:49.432981382 +0200
+++ b/target/linux/lantiq/dts/BTHOMEHUBV3A.dts	2016-07-05 19:03:27.190038717 +0200
@@ -64,7 +64,7 @@
 						read-only;
 					};
 					partition at 64000 {
-						label = "uboot-config";
+						label = "uboot_env";
 						reg = <0x64000 0x004000>;
 					};
 					ath9k_cal: partition at 68000 {
@@ -85,7 +85,6 @@
 			ath9k_eep {
 				compatible = "ath9k,eeprom";
 				ath,eep-flash = <&ath9k_cal 0x0000>;
-				ath,mac-offset = <0x10c>;
 				ath,pci-slot = <14>;
 				ath,eep-endian;
 			};