[openwrt/openwrt] ath79: add support for ALFA Network WiFi CampPro Nano Duo

LEDE Commits lede-commits at lists.infradead.org
Tue Oct 22 03:28:28 PDT 2024


pepe2k pushed a commit to openwrt/openwrt.git, branch main:
https://git.openwrt.org/861a9dac68b9427758ed1771dfb533db2a5bb88e

commit 861a9dac68b9427758ed1771dfb533db2a5bb88e
Author: Piotr Dymacz <pepe2k at gmail.com>
AuthorDate: Mon Apr 22 11:01:52 2024 +0200

    ath79: add support for ALFA Network WiFi CampPro Nano Duo
    
    ALFA Network WiFi CampPro Nano Duo is a dual-radio Wi-Fi signal extender
    (router) in USB dongle form-factor (Type-A plug is used only for power),
    based on combination of two radio chipsets: Qualcomm QCA9531 (main SOC)
    and MediaTek MT7610U (connected over USB 2.0 interface).
    
    Specifications:
    
    - SOC:      QCA9531 v2 (650 MHz)
    - DRAM:     DDR2 128 MiB (Nanya NT5TU64M16HG-AC)
    - Flash:    16 MiB SPI NOR (Macronix MX25L12835F)
    - Ethernet: 1x 10/100 Mbps Ethernet (QCA9531)
    - Wi-Fi:    2x2:2 2.4   GHz Wi-Fi 4 (QCA9531)
                1x1:1 2.4/5 GHz Wi-Fi 5 (MT7610U)
    - Antenna:  3x RP-SMA (female) antenna connectors
    - LED:      1x orange (RJ45, power indicator)
                2x green  (status + RJ45 activity/link)
                1x blue   (Wi-Fi 2.4 GHz status)
    - Button:   1x button (reset)
    - UART:     1x 4-pin, 2.00 mm pitch header on PCB
    - Other:    external h/w watchdog (EM6324QYSP5B, enabled by default)
                GPIO-controlled USB power for MT7610U
    
    MAC addresses:
    
    - LAN:                 00:c0:ca:xx:xx:6d (art 0x2, -1)
    - 2.4 GHz (QCA9531):   00:c0:ca:xx:xx:6e (art 0x2, device's label)
    - 2.4/5 GHz (MT7610U): 00:c0:ca:xx:xx:6f (from eeprom)
    
    Flash instructions:
    
    You can use sysupgrade image directly in vendor firmware which is based
    on LEDE/OpenWrt. Alternatively, you can use web recovery mode in U-Boot:
    
    1. Configure PC with static IP 192.168.1.2/24.
    2. Connect PC with RJ45 port, press the reset button, power up device,
       wait for first blink of status LED (indicates network setup), then
       keep button for 3 following blinks and release it.
    3. Open 192.168.1.1 address in your browser and upload sysupgrade image.
    
    Signed-off-by: Piotr Dymacz <pepe2k at gmail.com>
---
 .../qca9531_alfa-network_wifi-camppro-nano-duo.dts | 60 ++++++++++++++++++++++
 .../ath79/generic/base-files/etc/board.d/01_leds   |  1 +
 .../generic/base-files/etc/board.d/02_network      |  2 +
 target/linux/ath79/image/generic.mk                | 10 ++++
 4 files changed, 73 insertions(+)

diff --git a/target/linux/ath79/dts/qca9531_alfa-network_wifi-camppro-nano-duo.dts b/target/linux/ath79/dts/qca9531_alfa-network_wifi-camppro-nano-duo.dts
new file mode 100644
index 0000000000..e505081f98
--- /dev/null
+++ b/target/linux/ath79/dts/qca9531_alfa-network_wifi-camppro-nano-duo.dts
@@ -0,0 +1,60 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include <dt-bindings/leds/common.h>
+
+#include "qca9531_alfa-network_r36a.dtsi"
+
+/ {
+	model = "ALFA Network WiFi CampPro Nano Duo";
+	compatible = "alfa-network,wifi-camppro-nano-duo", "qca,qca9531";
+
+	aliases {
+		led-boot = &led_status;
+		led-failsafe = &led_status;
+		led-running = &led_status;
+		led-upgrade = &led_status;
+	};
+
+	leds {
+		compatible = "gpio-leds";
+
+		pinctrl-names = "default";
+		pinctrl-0 = <&enable_gpio4>;
+
+		lan {
+			function = LED_FUNCTION_LAN;
+			color = <LED_COLOR_ID_GREEN>;
+			gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
+		};
+
+		led_status: status {
+			function = LED_FUNCTION_STATUS;
+			color = <LED_COLOR_ID_GREEN>;
+			gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
+		};
+
+		wlan2g {
+			function = LED_FUNCTION_WLAN_2GHZ;
+			color = <LED_COLOR_ID_BLUE>;
+			gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
+			linux,default-trigger = "phy1tpt";
+		};
+	};
+};
+
+&eth0 {
+	nvmem-cells = <&macaddr_art_1002 (-1)>;
+	nvmem-cell-names = "mac-address";
+};
+
+&eth1 {
+	compatible = "syscon", "simple-mfd";
+};
+
+&gpio_export {
+	usb-power {
+		gpio-export,name = "usb-power";
+		gpio-export,output = <0>;
+		gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
+	};
+};
diff --git a/target/linux/ath79/generic/base-files/etc/board.d/01_leds b/target/linux/ath79/generic/base-files/etc/board.d/01_leds
index 143309a8b2..0e5731dd74 100644
--- a/target/linux/ath79/generic/base-files/etc/board.d/01_leds
+++ b/target/linux/ath79/generic/base-files/etc/board.d/01_leds
@@ -22,6 +22,7 @@ alcatel,hh40v)
 	;;
 alfa-network,ap121f|\
 alfa-network,ap121fe|\
+alfa-network,wifi-camppro-nano-duo|\
 avm,fritz450e|\
 glinet,6408|\
 glinet,6416|\
diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network
index 2ad4c899e0..8474c1c4c2 100644
--- a/target/linux/ath79/generic/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network
@@ -14,6 +14,7 @@ ath79_setup_interfaces()
 	alfa-network,ap121f|\
 	alfa-network,pi-wifi4|\
 	alfa-network,tube-2hq|\
+	alfa-network,wifi-camppro-nano-duo|\
 	araknis,an-300-ap-i-n|\
 	araknis,an-500-ap-i-ac|\
 	araknis,an-700-ap-i-ac|\
@@ -622,6 +623,7 @@ ath79_setup_macs()
 	alfa-network,pi-wifi4|\
 	alfa-network,r36a|\
 	alfa-network,tube-2hq|\
+	alfa-network,wifi-camppro-nano-duo|\
 	engenius,eap300-v2|\
 	engenius,ens202ext-v1)
 		label_mac=$(mtd_get_mac_binary art 0x1002)
diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk
index 06448f2172..c075f050db 100644
--- a/target/linux/ath79/image/generic.mk
+++ b/target/linux/ath79/image/generic.mk
@@ -346,6 +346,16 @@ define Device/alfa-network_tube-2hq
 endef
 TARGET_DEVICES += alfa-network_tube-2hq
 
+define Device/alfa-network_wifi-camppro-nano-duo
+  SOC := qca9531
+  DEVICE_VENDOR := ALFA Network
+  DEVICE_MODEL := WiFi CampPro Nano Duo
+  DEVICE_PACKAGES := kmod-usb2 kmod-mt76x0u -swconfig
+  IMAGE_SIZE := 15872k
+  SUPPORTED_DEVICES += campnano-duo
+endef
+TARGET_DEVICES += alfa-network_wifi-camppro-nano-duo
+
 define Device/allnet_all-wap02860ac
   $(Device/senao_loader_okli)
   SOC := qca9558




More information about the lede-commits mailing list