[openwrt/openwrt] ath79: Add support for Sophos AP15C
LEDE Commits
lede-commits at lists.infradead.org
Sat Nov 16 12:04:16 PST 2024
blocktrron pushed a commit to openwrt/openwrt.git, branch openwrt-24.10:
https://git.openwrt.org/2d465fbf570e1f3286210305a26580cd417fec7c
commit 2d465fbf570e1f3286210305a26580cd417fec7c
Author: David Lutz <kpanic at hirnduenger.de>
AuthorDate: Tue Nov 5 10:55:43 2024 +0100
ath79: Add support for Sophos AP15C
The Sophos AP15C uses the same hardware as the AP15, but has a reset button.
Based on:
commit 6f1efb289837 ("ath79: add support for Sophos AP100/AP55 family")
author Andrew Powers-Holmes <andrew at omnom.net>
Fri, 3 Sep 2021 15:53:57 +0200 (23:53 +1000)
committer Hauke Mehrtens <hauke at hauke-m.de>
Sat, 16 Apr 2022 16:59:29 +0200 (16:59 +0200)
Unique to AP15C:
- Reset button
- External RJ45 serial console port
Flashing instructions:
This firmware can be flashed either via a compatible Sophos SG or XG
firewall appliance, which does not require disassembling the device, or via
the U-Boot console available on the internal UART header.
To flash via XG appliance:
- Register on Sophos' website for a no-cost Home Use XG firewall license
- Download and install the XG software on a compatible PC or virtual
machine, complete initial appliance setup, and enable SSH console access
- Connect the target AP device to the XG appliance's LAN interface
- Approve the AP from the XG Web UI and wait until it shows as Active
(this can take 3-5 minutes)
- Connect to the XG appliance over SSH and access the Advanced Console
(Menu option 5, then menu option 3)
- Run `sudo awetool` and select the menu option to connect to an AP via
SSH. When prompted to enable SSH on the target AP, select Yes.
- Wait 2-3 minutes, then select the AP from the awetool menu again. This
will connect you to a root shell on the target AP.
- Copy the firmware to /tmp/openwrt.bin on the target AP via SCP/TFTP/etc
- Run `mtd -r write /tmp/openwrt.bin astaro_image`
- When complete, the access point will reboot to OpenWRT.
To flash via U-Boot serial console:
- Configure a TFTP server on your PC, and set IP address 192.168.99.8 with
netmask 255.255.255.0
- Copy the firmware .bin to the TFTP server and rename to 'uImage_AP15C'
- Open the target AP's enclosure and locate the 4-pin 3.3V UART header [4]
- Connect the AP ethernet to your PC's ethernet port
- Connect a terminal to the UART at 115200 8/N/1 as usual
- Power on the AP and press a key to cancel autoboot when prompted
- Run the following commands at the U-Boot console:
- `tftpboot`
- `cp.b $fileaddr 0x9f070000 $filesize`
- `boot`
- The access point will boot to OpenWRT.
Signed-off-by: David Lutz <kpanic at hirnduenger.de>
(cherry picked from commit a7abc7ec3b61be553f33c49e5acc90a4d539d992)
---
package/boot/uboot-envtools/files/ath79 | 1 +
target/linux/ath79/dts/qca9557_sophos_ap15c.dts | 159 +++++++++++++++++++++
.../generic/base-files/etc/board.d/02_network | 1 +
target/linux/ath79/image/generic.mk | 8 ++
4 files changed, 169 insertions(+)
diff --git a/package/boot/uboot-envtools/files/ath79 b/package/boot/uboot-envtools/files/ath79
index 1d9d3bcfaa..c6d23ce73d 100644
--- a/package/boot/uboot-envtools/files/ath79
+++ b/package/boot/uboot-envtools/files/ath79
@@ -163,6 +163,7 @@ ruckus,zf7372)
ubootenv_add_uci_config "/dev/mtd2" "0x0" "0x40000" "0x10000"
;;
sophos,ap15|\
+sophos,ap15c|\
sophos,ap55|\
sophos,ap55c|\
sophos,ap100|\
diff --git a/target/linux/ath79/dts/qca9557_sophos_ap15c.dts b/target/linux/ath79/dts/qca9557_sophos_ap15c.dts
new file mode 100644
index 0000000000..68d02e97a5
--- /dev/null
+++ b/target/linux/ath79/dts/qca9557_sophos_ap15c.dts
@@ -0,0 +1,159 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "qca955x.dtsi"
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+#include <dt-bindings/leds/common.h>
+
+/ {
+ compatible = "sophos,ap15c", "qca,qca9557";
+ model = "Sophos AP15C";
+
+ aliases {
+ led-boot = &led_status_green;
+ led-failsafe = &led_status_yellow;
+ led-running = &led_status_green;
+ led-upgrade = &led_status_yellow;
+ label-mac-device = ð0;
+ };
+
+ chosen {
+ bootargs = "console=ttyS0,115200n8";
+ };
+
+ keys {
+ compatible = "gpio-keys";
+
+ reset {
+ label = "reset";
+ linux,code = <KEY_RESTART>;
+ gpios = <&gpio 18 GPIO_ACTIVE_LOW>;
+ debounce-interval = <60>;
+ };
+ };
+
+ leds {
+ compatible = "gpio-leds";
+
+ led_status_green: status_green {
+ function = LED_FUNCTION_STATUS;
+ color = <LED_COLOR_ID_GREEN>;
+ gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
+ default-state = "on";
+ };
+
+ led_status_yellow: status_yellow {
+ function = LED_FUNCTION_STATUS;
+ color = <LED_COLOR_ID_YELLOW>;
+ gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+ };
+ };
+};
+
+&spi {
+ status = "okay";
+
+ flash at 0 {
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <25000000>;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition at 0 {
+ label = "u-boot";
+ reg = <0x000000 0x040000>;
+ read-only;
+ };
+
+ partition at 40000 {
+ label = "u-boot-env";
+ reg = <0x040000 0x010000>;
+ };
+
+ partition at 50000 {
+ label = "art";
+ reg = <0x050000 0x010000>;
+ read-only;
+
+ nvmem-layout {
+ compatible = "fixed-layout";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ cal_art_1000: calibration at 1000 {
+ reg = <0x1000 0x440>;
+ };
+ };
+ };
+
+ partition at 60000 {
+ label = "config";
+ reg = <0x060000 0x010000>;
+ read-only;
+
+ nvmem-layout {
+ compatible = "fixed-layout";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ macaddr_config_201a: macaddr at 201a {
+ reg = <0x201a 0x6>;
+ };
+ };
+ };
+
+ partition at 70000 {
+ compatible = "denx,uimage";
+ label = "firmware";
+ reg = <0x070000 0xf90000>;
+ };
+ };
+ };
+};
+
+&mdio0 {
+ status = "okay";
+
+ phy-mask = <0x10>;
+
+ phy4: ethernet-phy at 4 {
+ reg = <4>;
+ eee-broken-100tx;
+ eee-broken-1000t;
+ };
+};
+
+ð0 {
+ status = "okay";
+
+ pll-data = <0xa6000000 0xa0000101 0xa0001313>;
+
+ nvmem-cells = <&macaddr_config_201a>;
+ nvmem-cell-names = "mac-address";
+
+ phy-mode = "rgmii-id";
+ phy-handle = <&phy4>;
+
+ gmac_config: gmac-config {
+ device = <&gmac>;
+
+ rgmii-enabled = <1>;
+
+ rxdv-delay = <3>;
+ rxd-delay = <3>;
+ txen-delay = <3>;
+ txd-delay = <3>;
+ };
+};
+
+&wmac {
+ status = "okay";
+
+ nvmem-cells = <&cal_art_1000>;
+ nvmem-cell-names = "calibration";
+};
diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network
index 8474c1c4c2..8f79a3fad8 100644
--- a/target/linux/ath79/generic/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network
@@ -76,6 +76,7 @@ ath79_setup_interfaces()
ruckus,zf7351|\
siemens,ws-ap3610|\
sophos,ap15|\
+ sophos,ap15c|\
sophos,ap55|\
sophos,ap55c|\
sophos,ap100|\
diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk
index c075f050db..0173f5cb16 100644
--- a/target/linux/ath79/image/generic.mk
+++ b/target/linux/ath79/image/generic.mk
@@ -2972,6 +2972,14 @@ define Device/sophos_ap15
endef
TARGET_DEVICES += sophos_ap15
+define Device/sophos_ap15c
+ SOC := qca9557
+ DEVICE_VENDOR := Sophos
+ DEVICE_MODEL := AP15C
+ IMAGE_SIZE := 15936k
+endef
+TARGET_DEVICES += sophos_ap15c
+
define Device/sophos_ap55
SOC := qca9558
DEVICE_VENDOR := Sophos
More information about the lede-commits
mailing list