[openwrt/openwrt] ramips: mt7621: add support for Cudy X6 v2
LEDE Commits
lede-commits at lists.infradead.org
Tue May 2 09:26:06 PDT 2023
blocktrron pushed a commit to openwrt/openwrt.git, branch master:
https://git.openwrt.org/e38de40f8dd350344407fe5a91e81191f6960804
commit e38de40f8dd350344407fe5a91e81191f6960804
Author: Felix Baumann <felix.bau at gmx.de>
AuthorDate: Fri Apr 21 03:39:38 2023 +0200
ramips: mt7621: add support for Cudy X6 v2
Rename existing device to v1 and create common .dtsi
Difference to v1: 16MB Flash
Specifications:
SoC: MediaTek MT7621
RAM: 256 MB
Flash: 16 MB (SPI NOR, XM25QH128C on my device)
WiFi: MediaTek MT7915E
Switch: 1 WAN, 4 LAN (Gigabit)
Buttons: Reset, WPS
LEDs: Two Power LEDs (blue and red; together they form purple)
Power: DC 12V 1A center positive
Serial: 115200 8N1
C440 - (3V3 - GND - RX - TX) - C41 | v1 and v2
(P - G - R - T) | v2 labels them on the board
Installation:
Download and flash the manufacturer's built OpenWrt image available at
http://www.cudytech.com/openwrt_software_download
Install the new OpenWrt image via luci (System -> Backup/Flash firmware)
Be sure to NOT keep settings.
Recovery:
Loads only signed manufacture firmware due to bootloader RSA verification
Serve tftp-recovery image as /recovery.bin on 192.168.1.88/24
Connect to any lan ethernet port
Power on the device while holding the reset button
Wait at least 8 seconds before releasing reset button for image to
download
MAC addresses as verified by OEM firmware:
use address source
LAN f4:a4:54:86:75:a2 label
WAN f4:a4:54:86:75:a3 label + 1
2g f4:a4:54:86:75:a2 label
5g f6:a4:54:b6:75:a2 label + LA-Bit set + 4th oktet increased
The label MAC address is found in bdinfo 0xde00.
Signed-off-by: Felix Baumann <felix.bau at gmx.de>
---
target/linux/ramips/dts/mt7621_cudy_x6-v1.dts | 58 ++++++++++++++++++++++
target/linux/ramips/dts/mt7621_cudy_x6-v2.dts | 58 ++++++++++++++++++++++
.../{mt7621_cudy_x6.dts => mt7621_cudy_x6.dtsi} | 51 ++-----------------
target/linux/ramips/image/mt7621.mk | 19 +++++--
.../etc/hotplug.d/ieee80211/10_fix_wifi_mac | 3 +-
5 files changed, 137 insertions(+), 52 deletions(-)
diff --git a/target/linux/ramips/dts/mt7621_cudy_x6-v1.dts b/target/linux/ramips/dts/mt7621_cudy_x6-v1.dts
new file mode 100644
index 0000000000..cfae15e565
--- /dev/null
+++ b/target/linux/ramips/dts/mt7621_cudy_x6-v1.dts
@@ -0,0 +1,58 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "mt7621_cudy_x6.dtsi"
+
+/ {
+ compatible = "cudy,x6-v1", "mediatek,mt7621-soc";
+ model = "CUDY X6 v1";
+};
+
+&partitions {
+ partition at 50000 {
+ compatible = "denx,uimage";
+ label = "firmware";
+ reg = <0x50000 0x1f80000>;
+ };
+
+ partition at 1fd0000 {
+ label = "debug";
+ reg = <0x1fd0000 0x10000>;
+ read-only;
+ };
+
+ partition at 1fe0000 {
+ label = "backup";
+ reg = <0x1fe0000 0x10000>;
+ read-only;
+ };
+
+ partition at 1ff0000 {
+ label = "bdinfo";
+ reg = <0x1ff0000 0x10000>;
+ read-only;
+
+ compatible = "nvmem-cells";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ macaddr_bdinfo_de00: macaddr at de00 {
+ reg = <0xde00 0x6>;
+ };
+ };
+};
+
+&gmac0 {
+ nvmem-cells = <&macaddr_bdinfo_de00>;
+ nvmem-cell-names = "mac-address";
+};
+
+&gmac1 {
+ nvmem-cells = <&macaddr_bdinfo_de00>;
+ nvmem-cell-names = "mac-address";
+ mac-address-increment = <1>;
+};
+
+&wifi {
+ nvmem-cells = <&macaddr_bdinfo_de00>;
+ nvmem-cell-names = "mac-address";
+};
diff --git a/target/linux/ramips/dts/mt7621_cudy_x6-v2.dts b/target/linux/ramips/dts/mt7621_cudy_x6-v2.dts
new file mode 100644
index 0000000000..16fa15befc
--- /dev/null
+++ b/target/linux/ramips/dts/mt7621_cudy_x6-v2.dts
@@ -0,0 +1,58 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "mt7621_cudy_x6.dtsi"
+
+/ {
+ compatible = "cudy,x6-v2", "mediatek,mt7621-soc";
+ model = "CUDY X6 v2";
+};
+
+&partitions {
+ partition at 50000 {
+ compatible = "denx,uimage";
+ label = "firmware";
+ reg = <0x50000 0xf80000>;
+ };
+
+ partition at fd0000 {
+ label = "debug";
+ reg = <0xfd0000 0x10000>;
+ read-only;
+ };
+
+ partition at fe0000 {
+ label = "backup";
+ reg = <0xfe0000 0x10000>;
+ read-only;
+ };
+
+ partition at ff0000 {
+ label = "bdinfo";
+ reg = <0xff0000 0x10000>;
+ read-only;
+
+ compatible = "nvmem-cells";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ macaddr_bdinfo_de00: macaddr at de00 {
+ reg = <0xde00 0x6>;
+ };
+ };
+};
+
+&gmac0 {
+ nvmem-cells = <&macaddr_bdinfo_de00>;
+ nvmem-cell-names = "mac-address";
+};
+
+&gmac1 {
+ nvmem-cells = <&macaddr_bdinfo_de00>;
+ nvmem-cell-names = "mac-address";
+ mac-address-increment = <1>;
+};
+
+&wifi {
+ nvmem-cells = <&macaddr_bdinfo_de00>;
+ nvmem-cell-names = "mac-address";
+};
diff --git a/target/linux/ramips/dts/mt7621_cudy_x6.dts b/target/linux/ramips/dts/mt7621_cudy_x6.dtsi
similarity index 68%
rename from target/linux/ramips/dts/mt7621_cudy_x6.dts
rename to target/linux/ramips/dts/mt7621_cudy_x6.dtsi
index 5d5bb5150c..4c34f58a4b 100644
--- a/target/linux/ramips/dts/mt7621_cudy_x6.dts
+++ b/target/linux/ramips/dts/mt7621_cudy_x6.dtsi
@@ -6,9 +6,6 @@
#include <dt-bindings/input/input.h>
/ {
- compatible = "cudy,x6", "mediatek,mt7621-soc";
- model = "CUDY X6";
-
aliases {
led-boot = &led_internet_blue;
led-failsafe = &led_internet_red;
@@ -61,7 +58,7 @@
reg = <0>;
spi-max-frequency = <50000000>;
- partitions {
+ partitions: partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
@@ -84,37 +81,7 @@
read-only;
};
- partition at 50000 {
- compatible = "denx,uimage";
- label = "firmware";
- reg = <0x50000 0x1f80000>;
- };
-
- partition at 1fd0000 {
- label = "debug";
- reg = <0x1fd0000 0x10000>;
- read-only;
- };
-
- partition at 1fe0000 {
- label = "backup";
- reg = <0x1fe0000 0x10000>;
- read-only;
- };
-
- partition at 1ff0000 {
- label = "bdinfo";
- reg = <0x1ff0000 0x10000>;
- read-only;
-
- compatible = "nvmem-cells";
- #address-cells = <1>;
- #size-cells = <1>;
-
- macaddr_bdinfo_de00: macaddr at de00 {
- reg = <0xde00 0x6>;
- };
- };
+ /* additional partitions in DTS */
};
};
};
@@ -124,30 +91,18 @@
};
&pcie1 {
- wifi at 0,0 {
+ wifi:wifi at 0,0 {
compatible = "mediatek,mt76";
reg = <0x0000 0 0 0 0>;
mediatek,mtd-eeprom = <&factory 0x0000>;
mediatek,disable-radar-background;
-
- nvmem-cells = <&macaddr_bdinfo_de00>;
- nvmem-cell-names = "mac-address";
};
};
-&gmac0 {
- nvmem-cells = <&macaddr_bdinfo_de00>;
- nvmem-cell-names = "mac-address";
-};
-
&gmac1 {
status = "okay";
label = "wan";
phy-handle = <ðphy4>;
-
- nvmem-cells = <&macaddr_bdinfo_de00>;
- nvmem-cell-names = "mac-address";
- mac-address-increment = <1>;
};
&mdio {
diff --git a/target/linux/ramips/image/mt7621.mk b/target/linux/ramips/image/mt7621.mk
index 24daba43aa..135febe3a6 100644
--- a/target/linux/ramips/image/mt7621.mk
+++ b/target/linux/ramips/image/mt7621.mk
@@ -543,16 +543,29 @@ define Device/cudy_wr2100
endef
TARGET_DEVICES += cudy_wr2100
-define Device/cudy_x6
+define Device/cudy_x6-v1
$(Device/dsa-migration)
IMAGE_SIZE := 32256k
DEVICE_VENDOR := Cudy
DEVICE_MODEL := X6
+ DEVICE_VARIANT := v1
UIMAGE_NAME := R13
DEVICE_PACKAGES := kmod-mt7915-firmware -uboot-envtools
- SUPPORTED_DEVICES += R13
+ SUPPORTED_DEVICES += cudy,x6 R13
+endef
+TARGET_DEVICES += cudy_x6-v1
+
+define Device/cudy_x6-v2
+ $(Device/dsa-migration)
+ IMAGE_SIZE := 15872k
+ DEVICE_VENDOR := Cudy
+ DEVICE_MODEL := X6
+ DEVICE_VARIANT := v2
+ UIMAGE_NAME := R30
+ DEVICE_PACKAGES := kmod-mt7915-firmware -uboot-envtools
+ SUPPORTED_DEVICES += cudy,x6 R30
endef
-TARGET_DEVICES += cudy_x6
+TARGET_DEVICES += cudy_x6-v2
define Device/dlink_dap-1620-b1
DEVICE_VENDOR := D-Link
diff --git a/target/linux/ramips/mt7621/base-files/etc/hotplug.d/ieee80211/10_fix_wifi_mac b/target/linux/ramips/mt7621/base-files/etc/hotplug.d/ieee80211/10_fix_wifi_mac
index 746a88bd12..80c7273543 100644
--- a/target/linux/ramips/mt7621/base-files/etc/hotplug.d/ieee80211/10_fix_wifi_mac
+++ b/target/linux/ramips/mt7621/base-files/etc/hotplug.d/ieee80211/10_fix_wifi_mac
@@ -27,7 +27,8 @@ case "$board" in
hw_mac_addr=$(macaddr_unsetbit $hw_mac_addr 28)
[ "$PHYNBR" = "1" ] && macaddr_setbit_la $hw_mac_addr > /sys${DEVPATH}/macaddress
;;
- cudy,x6)
+ cudy,x6-v1|\
+ cudy,x6-v2)
hw_mac_addr="$(mtd_get_mac_binary bdinfo 0xde00)"
[ "$PHYNBR" = "1" ] && \
macaddr_setbit_la "$(macaddr_add $hw_mac_addr 0x100000)" > /sys${DEVPATH}/macaddress
More information about the lede-commits
mailing list