[openwrt/openwrt] ath79: add support for Alcatel HH40V
LEDE Commits
lede-commits at lists.infradead.org
Sun Apr 23 10:33:37 PDT 2023
hauke pushed a commit to openwrt/openwrt.git, branch master:
https://git.openwrt.org/097f350aebc542963c7208af4973ff17e01ce76e
commit 097f350aebc542963c7208af4973ff17e01ce76e
Author: Andreas Böhler <dev at aboehler.at>
AuthorDate: Sat Apr 1 21:57:22 2023 +0200
ath79: add support for Alcatel HH40V
The Alcatel HH40V is a CAT4 LTE router used by various ISPs.
Specifications
==============
SoC: QCA9531 650MHz
RAM: 128MiB
Flash: 32MiB SPI NOR
LAN: 1x 10/100MBit
WAN: 1x 10/100MBit
LTE: MDM9607 USB 2.0 (rndis configuration)
WiFi: 802.11n (SoC integrated)
MAC address assignment
======================
There are three MAC addresses stored in the flash ROM, the assignment
follows stock. The MAC on the label is the WiFi MAC address.
Installation (TFTP)
===================
1. Connect serial console
2. Configure static IP to 192.168.1.112
3. Put OpenWrt factory.bin file as firmware-system.bin
4. Press Power + WPS and plug in power
5. Keep buttons pressed until TFTP requests are visible
6. Wait for the system to finish flashing and wait for reboot
7. Bootup will fail as the kernel offset is wrong
8. Run "setenv bootcmd bootm 0x9f150000"
9. Reset board and enjoy OpenWrt
Installation (without UART)
===========================
Installation without UART is a bit tricky and requires several steps too
long for the commit message. Basic steps:
1. Create configure backup
2. Patch backup file to enable SSH
3. Login via SSH and configure the new bootcmd
3. Flash OpenWrt factory.bin image manually (sysupgrade doesn't work)
More detailed instructions will be provided on the Wiki page.
Tested by: Christian Heuff <christian at heuff.at>
Signed-off-by: Andreas Böhler <dev at aboehler.at>
---
package/boot/uboot-envtools/files/ath79 | 1 +
target/linux/ath79/dts/qca9531_alcatel_hh40v.dts | 172 +++++++++++++++++++++
.../ath79/generic/base-files/etc/board.d/01_leds | 6 +
.../generic/base-files/etc/board.d/02_network | 1 +
target/linux/ath79/image/generic.mk | 12 ++
5 files changed, 192 insertions(+)
diff --git a/package/boot/uboot-envtools/files/ath79 b/package/boot/uboot-envtools/files/ath79
index c7049f7029..47271453f6 100644
--- a/package/boot/uboot-envtools/files/ath79
+++ b/package/boot/uboot-envtools/files/ath79
@@ -12,6 +12,7 @@ touch /etc/config/ubootenv
board=$(board_name)
case "$board" in
+alcatel,hh40v|\
alfa-network,ap121f|\
alfa-network,ap121fe|\
alfa-network,n2q|\
diff --git a/target/linux/ath79/dts/qca9531_alcatel_hh40v.dts b/target/linux/ath79/dts/qca9531_alcatel_hh40v.dts
new file mode 100644
index 0000000000..7873f75528
--- /dev/null
+++ b/target/linux/ath79/dts/qca9531_alcatel_hh40v.dts
@@ -0,0 +1,172 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "qca953x.dtsi"
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+/ {
+ compatible = "alcatel,hh40v", "qca,qca9531";
+ model = "Alcatel HH40V";
+
+ aliases {
+ label-mac-device = &wmac;
+ led-boot = &led_lan_link;
+ led-failsafe = &led_lan_link;
+ led-upgrade = &led_lan_link;
+ };
+
+ keys {
+ compatible = "gpio-keys";
+
+ reset {
+ label = "reset";
+ linux,code = <KEY_RESTART>;
+ gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
+ };
+
+ wps {
+ label = "wps";
+ linux,code = <KEY_WPS_BUTTON>;
+ gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
+ };
+
+ };
+
+ leds {
+ compatible = "gpio-leds";
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&jtag_disable_pins>;
+
+ lan_active {
+ label = "green:lan";
+ gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
+ };
+
+ led_lan_link: lan_link {
+ label = "orange:lan";
+ gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
+ };
+
+ wan_active {
+ label = "green:wan";
+ gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
+ };
+
+ wan_link {
+ label = "orange:wan";
+ gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+ };
+
+ wifi {
+ label = "blue:wifi";
+ gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
+ linux,default-trigger = "phy0tpt";
+ };
+ };
+};
+
+&usb0 {
+ status = "okay";
+
+ dr_mode = "host";
+};
+
+&usb_phy {
+ status = "okay";
+};
+
+&spi {
+ status = "okay";
+
+ /* Winbond W25Q256 SPI flash */
+ flash at 0 {
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <25000000>;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition at 0 {
+ label = "u-boot";
+ reg = <0x000000 0x040000>;
+ read-only;
+ };
+
+ partition at 40000 {
+ label = "u-boot-env";
+ reg = <0x040000 0x010000>;
+ };
+
+ partition at 50000 {
+ label = "oem";
+ reg = <0x050000 0x100000>;
+ read-only;
+ };
+
+ partition at 150000 {
+ compatible = "denx,uimage";
+ label = "firmware";
+ reg = <0x150000 0xea0000>;
+ };
+
+ art: partition at ff0000 {
+ label = "art";
+ reg = <0xff0000 0x010000>;
+ read-only;
+
+ compatible = "nvmem-cells";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ cal_art_1000: cal at 1000 {
+ reg = <0x1000 0x440>;
+ };
+
+ macaddr_art_0: macaddr at 0 {
+ reg = <0x0 0x6>;
+ };
+
+ macaddr_art_6: macaddr at 6 {
+ reg = <0x6 0x6>;
+ };
+
+ macaddr_art_1002: macaddr at 1002 {
+ reg = <0x1002 0x6>;
+ };
+ };
+ };
+ };
+};
+
+&mdio0 {
+ status = "okay";
+};
+
+
+ð0 {
+ status = "okay";
+
+ nvmem-cells = <&macaddr_art_0>;
+ nvmem-cell-names = "mac-address";
+
+ phy-handle = <&swphy4>;
+};
+
+ð1 {
+ compatible = "qca,qca9530-eth", "syscon", "simple-mfd";
+
+ nvmem-cells = <&macaddr_art_6>;
+ nvmem-cell-names = "mac-address";
+};
+
+&wmac {
+ status = "okay";
+
+ nvmem-cells = <&cal_art_1000>, <&macaddr_art_1002>;
+ nvmem-cell-names = "calibration", "mac-address";
+};
diff --git a/target/linux/ath79/generic/base-files/etc/board.d/01_leds b/target/linux/ath79/generic/base-files/etc/board.d/01_leds
index 5855d2a928..d3508049ba 100644
--- a/target/linux/ath79/generic/base-files/etc/board.d/01_leds
+++ b/target/linux/ath79/generic/base-files/etc/board.d/01_leds
@@ -10,6 +10,12 @@ case "$board" in
ucidef_set_led_netdev "lan" "LAN" "orange:eth0" "eth0"
ucidef_set_led_switch "wan" "WAN" "orange:eth1" "switch0" "0x04"
;;
+alcatel,hh40v)
+ ucidef_set_led_netdev "lan_data" "LAN Data" "green:lan" "eth1" "tx rx"
+ ucidef_set_led_netdev "lan_link" "LAN Link" "orange:lan" "eth1" "link"
+ ucidef_set_led_netdev "wan_data" "WAN Data" "green:wan" "eth0" "tx rx"
+ ucidef_set_led_netdev "wan_link" "WAN Link" "orange:wan" "eth0" "link"
+ ;;
alfa-network,ap121f|\
alfa-network,ap121fe|\
avm,fritz450e|\
diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network
index c6284edafd..1d89f0b86c 100644
--- a/target/linux/ath79/generic/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network
@@ -217,6 +217,7 @@ ath79_setup_interfaces()
ucidef_add_switch "switch0" \
"0 at eth0" "1:lan:1" "3:lan:4" "4:lan:3" "5:lan:2" "2:wan"
;;
+ alcatel,hh40v|\
comfast,cf-e110n-v2|\
comfast,cf-e120a-v3|\
comfast,cf-e314n-v2|\
diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk
index dda74f04f4..ecc46bc6b1 100644
--- a/target/linux/ath79/image/generic.mk
+++ b/target/linux/ath79/image/generic.mk
@@ -246,6 +246,18 @@ define Device/adtran_bsap1840
endef
TARGET_DEVICES += adtran_bsap1840
+define Device/alcatel_hh40v
+ SOC := qca9531
+ DEVICE_VENDOR := Alcatel
+ DEVICE_MODEL := HH40V
+ DEVICE_PACKAGES := kmod-usb2 kmod-usb-serial-option kmod-usb-net-rndis
+ IMAGE_SIZE := 14976k
+ IMAGES += factory.bin
+ IMAGE/factory.bin := append-kernel | pad-to $$$$(BLOCKSIZE) | \
+ append-rootfs | pad-rootfs
+endef
+TARGET_DEVICES += alcatel_hh40v
+
define Device/airtight_c-75
SOC := qca9550
DEVICE_VENDOR := AirTight Networks
More information about the lede-commits
mailing list