[openwrt/openwrt] realtek: split TP-Link SG2000 series devicetree

[LEDE Commits]

svanheule pushed a commit to openwrt/openwrt.git, branch master:
https://git.openwrt.org/bc9dcfb1ce656e1da694d9d9a6f927b3142ab76a

commit bc9dcfb1ce656e1da694d9d9a6f927b3142ab76a
Author: Alexandru Gagniuc <mr.nuke.me at gmail.com>
AuthorDate: Sat Aug 20 16:10:42 2022 -0500

    realtek: split TP-Link SG2000 series devicetree
    
    The TP-Link TL-SG2008, TL-SG2008P, and TL-SG2210P use the same board.
    The main difference is that some footprints are not populated in the
    lower-end models. To model this with minimal duplication, move the
    devicetree to a common dtsi, leaving out just the board name.
    
    Signed-off-by: Alexandru Gagniuc <mr.nuke.me at gmail.com>
    [remove port relabelling from commit message, already merged with commit
     18a2b29aa1c9 ("realtek: tl-sg2008p: fix labeling of lan ports")]
    Signed-off-by: Sander Vanheule <sander at svanheule.net>
---
 .../realtek/dts-5.10/rtl8380_tplink_sg2008p-v1.dts | 178 +--------------------
 ...k_sg2008p-v1.dts => rtl8380_tplink_sg2xxx.dtsi} |   3 -
 2 files changed, 1 insertion(+), 180 deletions(-)

diff --git a/target/linux/realtek/dts-5.10/rtl8380_tplink_sg2008p-v1.dts b/target/linux/realtek/dts-5.10/rtl8380_tplink_sg2008p-v1.dts
index d464921e50..0fef52984c 100644
--- a/target/linux/realtek/dts-5.10/rtl8380_tplink_sg2008p-v1.dts
+++ b/target/linux/realtek/dts-5.10/rtl8380_tplink_sg2008p-v1.dts
@@ -1,184 +1,8 @@
 // SPDX-License-Identifier: GPL-2.0-or-later
 
-#include "rtl838x.dtsi"
-
-#include <dt-bindings/input/input.h>
-#include <dt-bindings/gpio/gpio.h>
+#include "rtl8380_tplink_sg2xxx.dtsi"
 
 / {
 	compatible = "tplink,sg2008p-v1", "realtek,rtl838x-soc";
 	model = "TP-Link SG2008P v1";
-
-	aliases {
-		led-boot = &led_power;
-		led-failsafe = &led_power;
-		led-running = &led_power;
-		led-upgrade = &led_power;
-	};
-
-	memory at 0 {
-		device_type = "memory";
-		reg = <0x0 0x10000000>;
-	};
-
-	keys {
-		compatible = "gpio-keys";
-
-		reset {
-			label = "reset";
-			gpios = <&gpio0 2 GPIO_ACTIVE_LOW>;
-			linux,code = <KEY_RESTART>;
-		};
-	};
-
-	gpio-restart {
-		compatible = "gpio-restart";
-		gpios = <&gpio0 3 GPIO_ACTIVE_LOW>;
-	};
-
-	leds {
-		compatible = "gpio-leds";
-
-		led_power: led-0 {
-			label = "green:power";
-			gpios = <&gpio0 13 GPIO_ACTIVE_HIGH>;
-		};
-	};
-
-	i2c1: i2c-gpio-1 {
-		compatible = "i2c-gpio";
-		scl-gpios = <&gpio0 0 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
-		sda-gpios = <&gpio0 1 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
-		i2c-gpio,delay-us = <2>;
-		#address-cells = <1>;
-		#size-cells = <0>;
-
-		tps23861 at 28 {
-			compatible = "ti,tps23861";
-			reg = <0x28>;
-			shunt-resistor-micro-ohms = <255000>;
-		};
-	};
-
-	watchdog {
-		compatible = "linux,wdt-gpio";
-		gpios = <&gpio0 11 GPIO_ACTIVE_HIGH>;
-		hw_algo = "toggle";
-		/* SGM706 specs: typical 1.6s, but minimum 1.0s. */
-		hw_margin_ms = <1000>;
-	};
-
-	virtual_flash {
-		compatible = "mtd-concat";
-
-		devices = <&syspart &usrpart>;
-
-		partitions {
-			compatible = "fixed-partitions";
-			#address-cells = <1>;
-			#size-cells = <1>;
-
-			partition at 0 {
-				compatible = "denx,uimage";
-				label = "firmware";
-				reg = <0x0 0x1a00000>;
-			};
-		};
-	};
-};
-
-&gpio0 {
-	watchdog-enable {
-		gpio-hog;
-		gpios = <14 GPIO_ACTIVE_LOW>;
-		output-low;
-		line-name = "watchdog-enable";
-	};
-};
-
-&spi0 {
-	status = "okay";
-
-	flash at 0 {
-		compatible = "jedec,spi-nor";
-		reg = <0>;
-		spi-max-frequency = <10000000>;
-
-		partitions {
-			compatible = "fixed-partitions";
-			#address-cells = <1>;
-			#size-cells = <1>;
-
-			partition at 0 {
-				label = "u-boot";
-				reg = <0x0 0xe0000>;
-				read-only;
-			};
-			partition at e0000 {
-				label = "u-boot-env";
-				reg = <0xe0000 0x20000>;
-			};
-			syspart: partition at 100000 {
-				label = "sys";
-				reg = <0x100000 0x600000>;
-			};
-			usrpart: partition at 700000 {
-				label = "usrimg1";
-				reg = <0x700000 0x1400000>;
-			};
-			partition at 1b00000 {
-				label = "usrappfs";
-				reg = <0x1b00000 0x400000>;
-			};
-			partition at 1f00000 {
-				label = "para";
-				reg = <0x1f00000 0x100000>;
-				read-only;
-			};
-		};
-	};
-};
-
-&ethernet0 {
-	mdio: mdio-bus {
-		compatible = "realtek,rtl838x-mdio";
-		#address-cells = <1>;
-		#size-cells = <0>;
-
-		INTERNAL_PHY(8)
-		INTERNAL_PHY(9)
-		INTERNAL_PHY(10)
-		INTERNAL_PHY(11)
-		INTERNAL_PHY(12)
-		INTERNAL_PHY(13)
-		INTERNAL_PHY(14)
-		INTERNAL_PHY(15)
-	};
-};
-
-&switch0 {
-	ports {
-		#address-cells = <1>;
-		#size-cells = <0>;
-
-		SWITCH_PORT(15, 1, internal)
-		SWITCH_PORT(14, 2, internal)
-		SWITCH_PORT(13, 3, internal)
-		SWITCH_PORT(12, 4, internal)
-		SWITCH_PORT(11, 5, internal)
-		SWITCH_PORT(10, 6, internal)
-		SWITCH_PORT(9, 7, internal)
-		SWITCH_PORT(8, 8, internal)
-
-		port at 28 {
-			ethernet = <&ethernet0>;
-			reg = <28>;
-			phy-mode = "internal";
-
-			fixed-link {
-				speed = <1000>;
-				full-duplex;
-			};
-		};
-	};
 };
diff --git a/target/linux/realtek/dts-5.10/rtl8380_tplink_sg2008p-v1.dts b/target/linux/realtek/dts-5.10/rtl8380_tplink_sg2xxx.dtsi
similarity index 97%
copy from target/linux/realtek/dts-5.10/rtl8380_tplink_sg2008p-v1.dts
copy to target/linux/realtek/dts-5.10/rtl8380_tplink_sg2xxx.dtsi
index d464921e50..8aa82831ab 100644
--- a/target/linux/realtek/dts-5.10/rtl8380_tplink_sg2008p-v1.dts
+++ b/target/linux/realtek/dts-5.10/rtl8380_tplink_sg2xxx.dtsi
@@ -6,9 +6,6 @@
 #include <dt-bindings/gpio/gpio.h>
 
 / {
-	compatible = "tplink,sg2008p-v1", "realtek,rtl838x-soc";
-	model = "TP-Link SG2008P v1";
-
 	aliases {
 		led-boot = &led_power;
 		led-failsafe = &led_power;