[openwrt/openwrt] ath79: add support for Qxwlan E750A v4

LEDE Commits lede-commits at lists.infradead.org
Thu Oct 15 12:53:56 EDT 2020


adrian pushed a commit to openwrt/openwrt.git, branch master:
https://git.openwrt.org/5666ca913a879e499dabb7364fff5e080abe8819

commit 5666ca913a879e499dabb7364fff5e080abe8819
Author: Peng Zhang <sd20 at qxwlan.com>
AuthorDate: Wed Oct 14 15:47:35 2020 +0800

    ath79: add support for Qxwlan E750A v4
    
    Qxwlan E750A v4 is based on Qualcomm QCA9344.
    
    Specification:
    
     - 560/450/225 MHz (CPU/DDR/AHB)
     - 128 MB of RAM (DDR2)
     - 8/16 MB of FLASH (SPI NOR)
     - 2T2R 5G GHz (AR9344)
     - 2x 10/100 Mbps Ethernet (one port with PoE support)
     - 1x miniPCIe slot (USB 2.0 bus only)
     - 7x LED (6 driven by GPIO)
     - 1x button (reset)
     - 1x DC jack for main power input (9-48 V)
     - UART (J23) and LEDs (J2) headers on PCB
    
    Flash instruction:
    
       1.Using tftp mode with UART connection and original LEDE image
          - Configure PC with static IP 192.168.1.10 and tftp server.
          - Rename "openwrt-ar71xx-generic-xxx-squashfs-sysupgrade.bin"
            to "firmware.bin" and place it in tftp server directory.
          - Connect PC with one of LAN ports, power up the router and press
            key "Enter" to access U-Boot CLI.
          - Use the following commands to update the device to LEDE:
            run lfw
          - After that the device will reboot and boot to LEDE.
          - Wait until all LEDs stops flashing and use the router.
    
       2.Using httpd mode with Web UI connection and original LEDE image
          - Configure PC with static IP 192.168.1.xxx(2-255) and tftp server.
          - Connect PC with one of LAN ports,press the reset button, power up
            the router and keep button pressed for around 6-7 seconds, until
            leds flashing.
          - Open your browser and enter 192.168.1.1,You will see the upgrade
            interface, select "openwrt-ar71xx-generic-xxx-squashfs-
            sysupgrade.bin" and click the upgrade button.
          - After that the device will reboot and boot to LEDE.
          - Wait until all LEDs stops flashing and use the router.
    
    Signed-off-by: Peng Zhang <sd20 at qxwlan.com>
    [cut out of bigger patch, alter use of DEVICE_VARIANT, merge case
    in 01_leds, use lower case for v4]
    Signed-off-by: Adrian Schmutzler <freifunk at adrianschmutzler.de>
---
 .../linux/ath79/dts/ar9344_qxwlan_e750a-v4-16m.dts |  49 +++++++++
 .../linux/ath79/dts/ar9344_qxwlan_e750a-v4-8m.dts  |  49 +++++++++
 target/linux/ath79/dts/ar9344_qxwlan_e750x.dtsi    | 113 +++++++++++++++++++++
 .../ath79/generic/base-files/etc/board.d/01_leds   |   4 +-
 target/linux/ath79/image/generic.mk                |  21 ++++
 5 files changed, 235 insertions(+), 1 deletion(-)

diff --git a/target/linux/ath79/dts/ar9344_qxwlan_e750a-v4-16m.dts b/target/linux/ath79/dts/ar9344_qxwlan_e750a-v4-16m.dts
new file mode 100644
index 0000000000..61389be127
--- /dev/null
+++ b/target/linux/ath79/dts/ar9344_qxwlan_e750a-v4-16m.dts
@@ -0,0 +1,49 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "ar9344_qxwlan_e750x.dtsi"
+
+/ {
+	model = "Qxwlan E750A v4 16M";
+	compatible = "qxwlan,e750a-v4-16m", "qca,ar9344";
+};
+
+&leds {
+	lan {
+		label = "green:lan";
+		gpios = <&gpio 19 GPIO_ACTIVE_LOW>;
+	};
+
+	wan {
+		label = "green:wan";
+		gpios = <&gpio 18 GPIO_ACTIVE_LOW>;
+	};
+};
+
+&eth0 {
+	status = "okay";
+
+	phy-handle = <&swphy4>;
+
+	mtd-mac-address = <&pridata 0x400>;
+	mtd-mac-address-increment = <1>;
+};
+
+&eth1 {
+	status = "okay";
+
+	mtd-mac-address = <&pridata 0x400>;
+
+	gmac-config {
+		device = <&gmac>;
+		switch-phy-swap = <0>;
+		switch-only-mode = <1>;
+	};
+};
+
+&partitions {
+	partition at 70000 {
+		compatible = "denx,uimage";
+		label = "firmware";
+		reg = <0x070000 0xf90000>;
+	};
+};
diff --git a/target/linux/ath79/dts/ar9344_qxwlan_e750a-v4-8m.dts b/target/linux/ath79/dts/ar9344_qxwlan_e750a-v4-8m.dts
new file mode 100644
index 0000000000..e232cdab24
--- /dev/null
+++ b/target/linux/ath79/dts/ar9344_qxwlan_e750a-v4-8m.dts
@@ -0,0 +1,49 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "ar9344_qxwlan_e750x.dtsi"
+
+/ {
+	model = "Qxwlan E750A v4 8M";
+	compatible = "qxwlan,e750a-v4-8m", "qca,ar9344";
+};
+
+&leds {
+	lan {
+		label = "green:lan";
+		gpios = <&gpio 19 GPIO_ACTIVE_LOW>;
+	};
+
+	wan {
+		label = "green:wan";
+		gpios = <&gpio 18 GPIO_ACTIVE_LOW>;
+	};
+};
+
+&eth0 {
+	status = "okay";
+
+	phy-handle = <&swphy4>;
+
+	mtd-mac-address = <&pridata 0x400>;
+	mtd-mac-address-increment = <1>;
+};
+
+&eth1 {
+	status = "okay";
+
+	mtd-mac-address = <&pridata 0x400>;
+
+	gmac-config {
+		device = <&gmac>;
+		switch-phy-swap = <0>;
+		switch-only-mode = <1>;
+	};
+};
+
+&partitions {
+	partition at 70000 {
+		compatible = "denx,uimage";
+		label = "firmware";
+		reg = <0x070000 0x790000>;
+	};
+};
diff --git a/target/linux/ath79/dts/ar9344_qxwlan_e750x.dtsi b/target/linux/ath79/dts/ar9344_qxwlan_e750x.dtsi
new file mode 100644
index 0000000000..2cd7b446c6
--- /dev/null
+++ b/target/linux/ath79/dts/ar9344_qxwlan_e750x.dtsi
@@ -0,0 +1,113 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "ar9344.dtsi"
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+/ {
+	aliases {
+		label-mac-device = &eth0;
+		led-boot = &led_system;
+		led-failsafe = &led_system;
+		led-running = &led_system;
+		led-upgrade = &led_system;
+	};
+
+	keys {
+		compatible = "gpio-keys";
+
+		reset {
+			label = "reset";
+			linux,code = <KEY_RESTART>;
+			gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
+			debounce-interval = <60>;
+		};
+	};
+
+	leds: leds {
+		compatible = "gpio-leds";
+
+		led_system: system {
+			label = "green:system";
+			gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+			default-state = "on";
+		};
+
+		sig1 {
+			label = "green:sig1";
+			gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
+		};
+
+		sig2 {
+			label = "green:sig2";
+			gpios = <&gpio 20 GPIO_ACTIVE_LOW>;
+		};
+
+		wlan {
+			label = "green:wlan";
+			gpios = <&gpio 21 GPIO_ACTIVE_LOW>;
+			linux,default-trigger = "phy0tpt";
+		};
+	};
+};
+
+&pcie {
+	status = "okay";
+};
+
+&spi {
+	status = "okay";
+
+	num-cs = <1>;
+
+	flash at 0 {
+		compatible = "jedec,spi-nor";
+		reg = <0>;
+		spi-max-frequency = <25000000>;
+
+		partitions: partitions {
+			compatible = "fixed-partitions";
+			#address-cells = <1>;
+			#size-cells = <1>;
+
+			partition at 0 {
+				label = "u-boot";
+				reg = <0x000000 0x040000>;
+				read-only;
+			};
+
+			partition at 40000 {
+				label = "u-boot-env";
+				reg = <0x040000 0x010000>;
+				read-only;
+			};
+
+			pridata: partition at 50000 {
+				label = "pri-data";
+				reg = <0x050000 0x010000>;
+				read-only;
+			};
+
+			art: partition at 60000 {
+				label = "art";
+				reg = <0x060000 0x010000>;
+				read-only;
+			};
+		};
+	};
+};
+
+&ref {
+	clock-frequency = <40000000>;
+};
+
+&uart {
+	status = "okay";
+};
+
+&wmac {
+	status = "okay";
+
+	mtd-cal-data = <&art 0x1000>;
+};
diff --git a/target/linux/ath79/generic/base-files/etc/board.d/01_leds b/target/linux/ath79/generic/base-files/etc/board.d/01_leds
index cc5a930531..0c130e329e 100755
--- a/target/linux/ath79/generic/base-files/etc/board.d/01_leds
+++ b/target/linux/ath79/generic/base-files/etc/board.d/01_leds
@@ -194,7 +194,9 @@ etactica,eg200)
 	ucidef_set_led_netdev "lan" "LAN" "red:eth0" "eth0"
 	ucidef_set_led_oneshot "modbus" "Modbus" "red:modbus" "100" "33"
 	;;
-glinet,gl-mifi)
+glinet,gl-mifi|\
+qxwlan,e750a-v4-8m|\
+qxwlan,e750a-v4-16m)
 	ucidef_set_led_switch "lan" "LAN" "green:lan" "switch0" "0x02"
 	ucidef_set_led_netdev "wan" "WAN" "green:wan" "eth1"
 	;;
diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk
index c0aacd7ff9..f15d7a3b89 100644
--- a/target/linux/ath79/image/generic.mk
+++ b/target/linux/ath79/image/generic.mk
@@ -1475,6 +1475,27 @@ define Device/qihoo_c301
 endef
 TARGET_DEVICES += qihoo_c301
 
+define Device/qxwlan_e750a-v4
+  SOC := ar9344
+  DEVICE_VENDOR := Qxwlan
+  DEVICE_MODEL := E750A
+  DEVICE_PACKAGES := kmod-usb2
+endef
+
+define Device/qxwlan_e750a-v4-16m
+  $(Device/qxwlan_e750a-v4)
+  DEVICE_VARIANT := v4 (16M)
+  IMAGE_SIZE := 15936k
+endef
+TARGET_DEVICES += qxwlan_e750a-v4-16m
+
+define Device/qxwlan_e750a-v4-8m
+  $(Device/qxwlan_e750a-v4)
+  DEVICE_VARIANT := v4 (8M)
+  IMAGE_SIZE := 7744k
+endef
+TARGET_DEVICES += qxwlan_e750a-v4-8m
+
 define Device/rosinson_wr818
   SOC := qca9563
   DEVICE_VENDOR := Rosinson



More information about the lede-commits mailing list