[openwrt/openwrt] ramips: add support for ASUS RT-N56U B1
LEDE Commits
lede-commits at lists.infradead.org
Sat Nov 28 14:51:55 EST 2020
adrian pushed a commit to openwrt/openwrt.git, branch master:
https://git.openwrt.org/6d98c098e48414b0da8aa6c25aa9044a201c1ba6
commit 6d98c098e48414b0da8aa6c25aa9044a201c1ba6
Author: Pavel Chervontsev <cherpash at gmail.com>
AuthorDate: Mon Nov 2 14:50:01 2020 +0300
ramips: add support for ASUS RT-N56U B1
Specifications:
SoC: MediaTek MT7621ST (880 MHz)
FLASH: 16 MiB (Macronix MX25L12835FM2I-10G)
RAM: 128 MiB (Nanya NT5CB64M16FP-DH)
WiFi: MediaTek MT7603EN bgn 2x2:2
WiFi: MediaTek MT7612EN an 2x2:2
BTN: Reset, WPS
LED: - Power
- WiFi 2.4 GHz
- WiFi 5 GHz
- WAN
- LAN {1-4}
- USB {1-2}
UART: UART is present as pin hole next to the aluminium capacitor.
3V3 - RX - GND - TX / 115200-8N1
3V3 is the nearest on the aluminium capacitor and nut hole (pin1).
USB: 2 ports
POWER: 12VDC, 1.5A (Barrel 5.5x2.1)
Installation:
Via TFTP:
Set your computers IP-Address to 192.168.1.75
Power up the Router with the Reset button pressed.
Release the Reset button after 5 seconds.
Upload OpenWRT sysupgrade image via TFTP:
tftp -4 -v -m binary 192.168.1.1 -c put IMAGE
MAC addresses:
0x4 *:98 2g/wan, label
0x22 *:9c
0x28 *:98
0x8004 *:9c 5g/lan
Though addresses are written to 0x22 and 0x28, it appears that the
vendor firmware actually only uses 0x4 and 0x8004. Thus, we do the
same here.
Signed-off-by: Pavel Chervontsev <cherpash at gmail.com>
[add MAC address overview, add label-mac-device, fix IMAGE_SIZE]
Signed-off-by: Adrian Schmutzler <freifunk at adrianschmutzler.de>
---
target/linux/ramips/dts/mt7621_asus_rt-n56u-b1.dts | 181 +++++++++++++++++++++
target/linux/ramips/image/mt7621.mk | 11 ++
.../ramips/mt7621/base-files/etc/board.d/01_leds | 4 +
3 files changed, 196 insertions(+)
diff --git a/target/linux/ramips/dts/mt7621_asus_rt-n56u-b1.dts b/target/linux/ramips/dts/mt7621_asus_rt-n56u-b1.dts
new file mode 100644
index 0000000000..b78e594ffd
--- /dev/null
+++ b/target/linux/ramips/dts/mt7621_asus_rt-n56u-b1.dts
@@ -0,0 +1,181 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "mt7621.dtsi"
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+/ {
+ compatible = "asus,rt-n56u-b1", "mediatek,mt7621-soc";
+ model = "ASUS RT-N56U B1";
+
+ aliases {
+ label-mac-device = &wan;
+ led-boot = &led_power;
+ led-failsafe = &led_power;
+ led-running = &led_power;
+ led-upgrade = &led_power;
+ };
+
+ chosen {
+ bootargs = "console=ttyS0,115200";
+ };
+
+ leds {
+ compatible = "gpio-leds";
+
+ led_power: power {
+ label = "blue:power";
+ gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
+ };
+
+ wlan2g {
+ label = "blue:wlan2g";
+ gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+ linux,default-trigger = "phy0tpt";
+ };
+
+ wlan5g {
+ label = "blue:wlan5g";
+ gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
+ linux,default-trigger = "phy1tpt";
+ };
+
+ wan {
+ label = "blue:wan";
+ gpios = <&gpio 7 GPIO_ACTIVE_LOW>;
+ };
+
+ lan {
+ label = "blue:lan";
+ gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
+ };
+
+ usb {
+ label = "blue:usb";
+ gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
+ trigger-sources = <&xhci_ehci_port1>, <&ehci_port2>;
+ linux,default-trigger = "usbport";
+ };
+ };
+
+ keys {
+ compatible = "gpio-keys";
+
+ wps {
+ label = "wps";
+ gpios = <&gpio 18 GPIO_ACTIVE_HIGH>;
+ linux,code = <KEY_WPS_BUTTON>;
+ debounce-interval = <60>;
+ };
+
+ reset {
+ label = "reset";
+ gpios = <&gpio 6 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_RESTART>;
+ debounce-interval = <60>;
+ };
+ };
+};
+
+&spi0 {
+ status = "okay";
+
+ flash at 0 {
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <50000000>;
+ m25p,fast-read;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition at 0 {
+ label = "u-boot";
+ reg = <0x0 0x30000>;
+ read-only;
+ };
+
+ partition at 30000 {
+ label = "config";
+ reg = <0x30000 0x10000>;
+ read-only;
+ };
+
+ factory: partition at 40000 {
+ label = "factory";
+ reg = <0x40000 0x10000>;
+ read-only;
+ };
+
+ partition at 50000 {
+ compatible = "denx,uimage";
+ label = "firmware";
+ reg = <0x50000 0xfb0000>;
+ };
+ };
+ };
+};
+
+&pcie {
+ status = "okay";
+};
+
+&pcie0 {
+ wifi at 0,0 {
+ compatible = "mediatek,mt76";
+ reg = <0x0000 0 0 0 0>;
+ mediatek,mtd-eeprom = <&factory 0x8000>;
+ };
+};
+
+&pcie1 {
+ wifi at 0,0 {
+ compatible = "mediatek,mt76";
+ reg = <0x0000 0 0 0 0>;
+ mediatek,mtd-eeprom = <&factory 0x0000>;
+ };
+};
+
+&gmac0 {
+ mtd-mac-address = <&factory 0x8004>;
+};
+
+&switch0 {
+ ports {
+ port at 0 {
+ status = "okay";
+ label = "lan4";
+ };
+
+ port at 1 {
+ status = "okay";
+ label = "lan3";
+ };
+
+ port at 2 {
+ status = "okay";
+ label = "lan2";
+ };
+
+ port at 3 {
+ status = "okay";
+ label = "lan1";
+ };
+
+ wan: port at 4 {
+ status = "okay";
+ label = "wan";
+ mtd-mac-address = <&factory 0x4>;
+ };
+ };
+};
+
+&state_default {
+ gpio {
+ groups = "uart3", "uart2", "jtag", "wdt";
+ function = "gpio";
+ };
+};
diff --git a/target/linux/ramips/image/mt7621.mk b/target/linux/ramips/image/mt7621.mk
index ce9a3ae3d2..7b8a73c1bd 100644
--- a/target/linux/ramips/image/mt7621.mk
+++ b/target/linux/ramips/image/mt7621.mk
@@ -188,6 +188,17 @@ define Device/asus_rt-ac85p
endef
TARGET_DEVICES += asus_rt-ac85p
+define Device/asus_rt-n56u-b1
+ $(Device/dsa-migration)
+ DEVICE_VENDOR := ASUS
+ DEVICE_MODEL := RT-N56U
+ DEVICE_VARIANT := B1
+ IMAGE_SIZE := 16064k
+ DEVICE_PACKAGES := kmod-mt7603 kmod-mt76x2 kmod-usb3 \
+ kmod-usb-ledtrig-usbport
+endef
+TARGET_DEVICES += asus_rt-n56u-b1
+
define Device/buffalo_wsr-1166dhp
$(Device/dsa-migration)
$(Device/uimage-lzma-loader)
diff --git a/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds b/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds
index 3dd2a218b9..cd1814cc2b 100755
--- a/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds
+++ b/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds
@@ -8,6 +8,10 @@ board=$(board_name)
board_config_update
case $board in
+asus,rt-n56u-b1)
+ ucidef_set_led_netdev "lan" "LAN link" "blue:lan" "br-lan"
+ ucidef_set_led_netdev "wan" "WAN link" "blue:wan" "wan"
+ ;;
d-team,newifi-d2)
ucidef_set_led_netdev "internet" "internet" "amber:internet" "wan"
ucidef_set_led_netdev "wlan2g" "WiFi 2.4GHz" "blue:wlan2g" "wlan0"
More information about the lede-commits
mailing list