[openwrt/openwrt] ramips: add support for D-Link DIR-1960 A1
LEDE Commits
lede-commits at lists.infradead.org
Mon Jul 27 07:03:10 EDT 2020
adrian pushed a commit to openwrt/openwrt.git, branch master:
https://git.openwrt.org/11bff24b3e1b10088bf6832447d18a9c9b17ef25
commit 11bff24b3e1b10088bf6832447d18a9c9b17ef25
Author: Josh Bendavid <joshbendavid at gmail.com>
AuthorDate: Tue Jul 14 17:39:21 2020 +0200
ramips: add support for D-Link DIR-1960 A1
This patch adds support for D-Link DIR-1960 A1. Given the similarity with
the DIR-1760/2660 A1, this patch also introduces a common DTSI which can
be shared with these devices, with support to be added in future commits.
Specifications:
* Board: AP-MTKH7-0002
* SoC: MediaTek MT7621AT
* RAM: 256 MB (DDR3)
* Flash: 128 MB (NAND)
* WiFi: MediaTek MT7615N (x2)
* Switch: 1 WAN, 4 LAN (Gigabit)
* Ports: 1 USB 3.0
* Buttons: Reset, WPS
* LEDs: Power (white/orange), Internet (white/orange), WiFi 2.4G (white),
WiFi 5G (white), USB 3.0 (white)
Notes:
* WiFi 2.4G and WiFi 5G LEDs are wired directly to the wireless chips
Installation:
* D-Link Recovery GUI: power down the router, press and hold the reset
button, then re-plug it. Keep the reset button pressed until the power
LED starts flashing orange, manually assign a static IP address under
the 192.168.0.xxx subnet (e.g. 192.168.0.2) and go to http://192.168.0.1
* Some modern browsers may have problems flashing via the Recovery GUI,
if that occurs consider uploading the firmware through cURL:
curl -v -i -F "firmware=@file.bin" 192.168.0.1
MAC addresses:
lan factory 0xe000 *:EB (label)
wan factory 0xe006 *:EE
2.4 factory 0xe000 +1 *:EC
5.0 factory 0xe000 +2 *:ED
Seems like vendor didn't replace the dummy entrys in the calibration data.
Signed-off-by: Josh Bendavid <joshbendavid at gmail.com>
[fix whitespace issues, create patch to merge DIR-1960 first, move
special WiFi MAC settings to DTS, extend commit message]
Signed-off-by: Adrian Schmutzler <freifunk at adrianschmutzler.de>
---
.../linux/ramips/dts/mt7621_dlink_dir-1960-a1.dts | 57 +++++++
.../linux/ramips/dts/mt7621_dlink_dir-xx60-a1.dtsi | 163 +++++++++++++++++++++
target/linux/ramips/image/mt7621.mk | 23 +++
.../ramips/mt7621/base-files/etc/board.d/01_leds | 3 +
.../mt7621/base-files/lib/upgrade/platform.sh | 1 +
5 files changed, 247 insertions(+)
diff --git a/target/linux/ramips/dts/mt7621_dlink_dir-1960-a1.dts b/target/linux/ramips/dts/mt7621_dlink_dir-1960-a1.dts
new file mode 100644
index 0000000000..ed8b188994
--- /dev/null
+++ b/target/linux/ramips/dts/mt7621_dlink_dir-1960-a1.dts
@@ -0,0 +1,57 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "mt7621_dlink_dir-xx60-a1.dtsi"
+
+/ {
+ compatible = "dlink,dir-1960-a1", "mediatek,mt7621-soc";
+ model = "D-Link DIR-1960 A1";
+
+ aliases {
+ led-boot = &led_power_orange;
+ led-failsafe = &led_power_white;
+ led-running = &led_power_white;
+ led-upgrade = &led_net_orange;
+ };
+
+ leds {
+ compatible = "gpio-leds";
+
+ led_power_orange: power_orange {
+ label = "dir-1960-a1:orange:power";
+ gpios = <&gpio 8 GPIO_ACTIVE_LOW>;
+ };
+
+ led_power_white: power_white {
+ label = "dir-1960-a1:white:power";
+ gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
+ };
+
+ led_net_orange: net_orange {
+ label = "dir-1960-a1:orange:net";
+ gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
+ };
+
+ net_white {
+ label = "dir-1960-a1:white:net";
+ gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
+ };
+
+ usb_white {
+ label = "dir-1960-a1:white:usb";
+ gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+ trigger-sources = <&xhci_ehci_port1>;
+ linux,default-trigger = "usbport";
+ };
+ };
+};
+
+&wifi0 {
+ mtd-mac-address = <&factory 0xe000>;
+ mtd-mac-address-increment = <1>;
+};
+
+&wifi1 {
+ mtd-mac-address = <&factory 0xe000>;
+ mtd-mac-address-increment = <2>;
+};
diff --git a/target/linux/ramips/dts/mt7621_dlink_dir-xx60-a1.dtsi b/target/linux/ramips/dts/mt7621_dlink_dir-xx60-a1.dtsi
new file mode 100644
index 0000000000..e194592b57
--- /dev/null
+++ b/target/linux/ramips/dts/mt7621_dlink_dir-xx60-a1.dtsi
@@ -0,0 +1,163 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "mt7621.dtsi"
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+/ {
+ aliases {
+ label-mac-device = &gmac0;
+ };
+
+ keys {
+ compatible = "gpio-keys";
+
+ reset {
+ label = "reset";
+ gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_RESTART>;
+ };
+
+ wps {
+ label = "wps";
+ gpios = <&gpio 18 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_WPS_BUTTON>;
+ };
+ };
+};
+
+&nand {
+ status = "okay";
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition at 0 {
+ label = "Bootloader";
+ reg = <0x0 0x80000>;
+ read-only;
+ };
+
+ partition at 80000 {
+ label = "config";
+ reg = <0x80000 0x80000>;
+ read-only;
+ };
+
+ factory: partition at 100000 {
+ label = "factory";
+ reg = <0x100000 0x40000>;
+ read-only;
+ };
+
+ partition at 140000 {
+ label = "config2";
+ reg = <0x140000 0x40000>;
+ read-only;
+ };
+
+ partition at 180000 {
+ label = "firmware";
+ compatible = "sge,uimage";
+ reg = <0x180000 0x2800000>;
+ };
+
+ partition at 2980000 {
+ label = "private";
+ reg = <0x2980000 0x2000000>;
+ read-only;
+ };
+
+ partition at 4980000 {
+ label = "firmware2";
+ compatible = "sge,uimage";
+ reg = <0x4980000 0x2800000>;
+ };
+
+ partition at 7180000 {
+ label = "mydlink";
+ reg = <0x7180000 0x600000>;
+ read-only;
+ };
+
+ partition at 7780000 {
+ label = "reserved";
+ reg = <0x7780000 0x880000>;
+ read-only;
+ };
+ };
+};
+
+&pcie {
+ status = "okay";
+};
+
+&pcie0 {
+ wifi0: wifi at 0,0 {
+ compatible = "mediatek,mt76";
+ reg = <0x0000 0 0 0 0>;
+ mediatek,mtd-eeprom = <&factory 0x0000>;
+ ieee80211-freq-limit = <2400000 2500000>;
+
+ led {
+ led-active-low;
+ };
+ };
+};
+
+&pcie1 {
+ wifi1: wifi at 0,0 {
+ compatible = "mediatek,mt76";
+ reg = <0x0000 0 0 0 0>;
+ mediatek,mtd-eeprom = <&factory 0x8000>;
+ ieee80211-freq-limit = <5000000 6000000>;
+
+ led {
+ led-active-low;
+ };
+ };
+};
+
+&gmac0 {
+ mtd-mac-address = <&factory 0xe000>;
+};
+
+&switch0 {
+ ports {
+ port at 0 {
+ status = "okay";
+ label = "lan4";
+ };
+
+ port at 1 {
+ status = "okay";
+ label = "lan3";
+ };
+
+ port at 2 {
+ status = "okay";
+ label = "lan2";
+ };
+
+ port at 3 {
+ status = "okay";
+ label = "lan1";
+ };
+
+ port at 4 {
+ status = "okay";
+ label = "wan";
+ mtd-mac-address = <&factory 0xe006>;
+ };
+ };
+};
+
+&state_default {
+ gpio {
+ groups = "i2c", "uart3", "jtag", "wdt";
+ function = "gpio";
+ };
+};
diff --git a/target/linux/ramips/image/mt7621.mk b/target/linux/ramips/image/mt7621.mk
index 6a9d49b32c..f13be3d3bc 100644
--- a/target/linux/ramips/image/mt7621.mk
+++ b/target/linux/ramips/image/mt7621.mk
@@ -232,6 +232,29 @@ define Device/dlink_dir-8xx-a1
check-size
endef
+define Device/dlink_dir-xx60-a1
+ BLOCKSIZE := 128k
+ PAGESIZE := 2048
+ KERNEL_SIZE := 4096k
+ IMAGE_SIZE := 40960k
+ UBINIZE_OPTS := -E 5
+ DEVICE_VENDOR := D-Link
+ DEVICE_PACKAGES := kmod-mt7615e kmod-mt7615-firmware wpad-basic \
+ kmod-usb3 kmod-usb-ledtrig-usbport
+ KERNEL := $$(KERNEL) | uimage-padhdr 96
+ IMAGES += factory.bin
+ IMAGE/sysupgrade.bin := sysupgrade-tar | append-metadata
+ IMAGE/factory.bin := append-kernel | pad-to $$(KERNEL_SIZE) | append-ubi | \
+ check-size
+endef
+
+define Device/dlink_dir-1960-a1
+ $(Device/dlink_dir-xx60-a1)
+ DEVICE_MODEL := DIR-1960
+ DEVICE_VARIANT := A1
+endef
+TARGET_DEVICES += dlink_dir-1960-a1
+
define Device/dlink_dir-860l-b1
$(Device/seama)
BLOCKSIZE := 64k
diff --git a/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds b/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds
index 43cd77ccd1..63c0bce083 100755
--- a/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds
+++ b/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds
@@ -26,6 +26,9 @@ d-team,pbr-m1|\
gehua,ghl-r-001)
ucidef_set_led_netdev "internet" "internet" "$boardname:blue:internet" "wan"
;;
+dlink,dir-1960-a1)
+ ucidef_set_led_netdev "wan" "wan" "$boardname:white:net" "wan"
+ ;;
dlink,dir-860l-b1|\
dlink,dir-867-a1|\
dlink,dir-878-a1|\
diff --git a/target/linux/ramips/mt7621/base-files/lib/upgrade/platform.sh b/target/linux/ramips/mt7621/base-files/lib/upgrade/platform.sh
index 01db733c98..a411a7a033 100755
--- a/target/linux/ramips/mt7621/base-files/lib/upgrade/platform.sh
+++ b/target/linux/ramips/mt7621/base-files/lib/upgrade/platform.sh
@@ -44,6 +44,7 @@ platform_do_upgrade() {
case "$board" in
asus,rt-ac65p|\
asus,rt-ac85p|\
+ dlink,dir-1960-a1|\
hiwifi,hc5962|\
linksys,ea7300-v1|\
linksys,ea7500-v2|\
More information about the lede-commits
mailing list