[openwrt/openwrt] ramips: add support for D-Link DIR-878 A1
LEDE Commits
lede-commits at lists.infradead.org
Mon Jul 13 16:45:36 EDT 2020
ynezz pushed a commit to openwrt/openwrt.git, branch master:
https://git.openwrt.org/d7233b0a6a9b8cb9207a74a8cb3d0525170cf504
commit d7233b0a6a9b8cb9207a74a8cb3d0525170cf504
Author: Mathieu Martin-Borret <mathieu.mb at protonmail.com>
AuthorDate: Fri Jul 10 13:49:20 2020 +1000
ramips: add support for D-Link DIR-878 A1
Specifications:
SoC: MT7621AT
RAM: 128MB
Flash: 16MB NOR SPI flash
WiFi: MT7615N (2.4GHz) and MT7615N (5Ghz)
LAN: 5x1000M
Firmware layout is Uboot with extra 96 bytes in header
Base PCB is AP-MTKH7-0002
LEDs Power Green,Power Orange,Internet Green,Internet Orange
LEDs "2.4G" Green & "5G" Green connected directly to wifi module
Buttons Reset,WPS,WIFI
Flashing instructions:
Upload image via emergency recovery mode
Push and hold reset button (on the back of the device) until power led
starts flashing (about 10 secs or so) while powering the device on.
Give it ~30 seconds, to boot the recovery mode GUI
Connect your client computer to LAN1 of the device
Set your client IP address manually to 192.168.0.2 / 255.255.255.0.
Call the recovery page for the device at http://192.168.0.1
Use the provided emergency web GUI to upload and flash a new firmware to
the device. Some browsers/OS combinations are known not to work, so if
you don't see the percentage complete displayed and moving within a few
seconds, restart the procedure from scratch and try anoher one,
or try the command line way.
Alternative method using command line on Linux:
curl -v -i -F "firmware=@openwrt-xxxx-squashfs-factory.bin" 192.168.0.1
Signed-off-by: Mathieu Martin-Borret <mathieu.mb at protonmail.com>
[use of generic uimage-padhdr in image generation code]
Signed-off-by: Petr Štetiar <ynezz at true.cz>
---
.../linux/ramips/dts/mt7621_dlink_dir-878-a1.dts | 181 +++++++++++++++++++++
target/linux/ramips/image/mt7621.mk | 15 ++
.../ramips/mt7621/base-files/etc/board.d/01_leds | 3 +-
3 files changed, 198 insertions(+), 1 deletion(-)
diff --git a/target/linux/ramips/dts/mt7621_dlink_dir-878-a1.dts b/target/linux/ramips/dts/mt7621_dlink_dir-878-a1.dts
new file mode 100644
index 0000000000..15c46cb5f7
--- /dev/null
+++ b/target/linux/ramips/dts/mt7621_dlink_dir-878-a1.dts
@@ -0,0 +1,181 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "mt7621.dtsi"
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+/ {
+ compatible = "dlink,dir-878-a1", "mediatek,mt7621-soc";
+ model = "D-Link DIR-878 A1";
+
+ aliases {
+ led-boot = &led_power_orange;
+ led-failsafe = &led_power_green;
+ led-running = &led_power_green;
+ led-upgrade = &led_net_orange;
+ label-mac-device = &gmac0;
+ };
+
+ chosen {
+ bootargs = "console=ttyS0,57600";
+ };
+
+ leds {
+ compatible = "gpio-leds";
+
+ led_power_orange: power_orange {
+ label = "dir-878-a1:orange:power";
+ gpios = <&gpio 8 GPIO_ACTIVE_LOW>;
+ };
+
+ led_power_green: power_green {
+ label = "dir-878-a1:green:power";
+ gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
+ };
+
+ led_net_orange: net_orange {
+ label = "dir-878-a1:orange:net";
+ gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
+ };
+
+ net_green {
+ label = "dir-878-a1:green:net";
+ gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
+ };
+ };
+
+ keys {
+ compatible = "gpio-keys";
+
+ reset {
+ label = "reset";
+ gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_RESTART>;
+ };
+
+ wps {
+ label = "wps";
+ gpios = <&gpio 18 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_WPS_BUTTON>;
+ };
+
+ wifi {
+ label = "wifi";
+ gpios = <&gpio 7 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_RFKILL>;
+ };
+ };
+};
+
+&spi0 {
+ status = "okay";
+
+ flash at 0 {
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <50000000>;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition at 0 {
+ label = "u-boot";
+ reg = <0x0 0x30000>;
+ read-only;
+ };
+
+ partition at 30000 {
+ label = "u-boot-env";
+ reg = <0x30000 0x10000>;
+ read-only;
+ };
+
+ factory: partition at 40000 {
+ label = "factory";
+ reg = <0x40000 0x20000>;
+ read-only;
+ };
+
+ partition at 60000 {
+ compatible = "sge,uimage";
+ label = "firmware";
+ reg = <0x60000 0xfa0000>;
+ };
+ };
+ };
+};
+
+&pcie {
+ status = "okay";
+};
+
+&pcie0 {
+ wifi at 0,0 {
+ compatible = "mediatek,mt76";
+ reg = <0x0000 0 0 0 0>;
+ mediatek,mtd-eeprom = <&factory 0x0000>;
+ ieee80211-freq-limit = <2400000 2500000>;
+
+ led {
+ led-active-low;
+ };
+ };
+};
+
+&pcie1 {
+ wifi at 0,0 {
+ compatible = "mediatek,mt76";
+ reg = <0x0000 0 0 0 0>;
+ mediatek,mtd-eeprom = <&factory 0x8000>;
+ ieee80211-freq-limit = <5000000 6000000>;
+
+ led {
+ led-active-low;
+ };
+ };
+};
+
+&gmac0 {
+ mtd-mac-address = <&factory 0xe000>;
+};
+
+&switch0 {
+ ports {
+ port at 0 {
+ status = "okay";
+ label = "lan4";
+ };
+
+ port at 1 {
+ status = "okay";
+ label = "lan3";
+ };
+
+ port at 2 {
+ status = "okay";
+ label = "lan2";
+ };
+
+ port at 3 {
+ status = "okay";
+ label = "lan1";
+ };
+
+ port at 4 {
+ status = "okay";
+ label = "wan";
+ mtd-mac-address = <&factory 0xe006>;
+ };
+ };
+};
+
+&state_default {
+ gpio {
+ groups = "i2c", "uart3", "jtag", "wdt";
+ function = "gpio";
+ };
+};
diff --git a/target/linux/ramips/image/mt7621.mk b/target/linux/ramips/image/mt7621.mk
index 9e5bd811b0..48561d5ff9 100644
--- a/target/linux/ramips/image/mt7621.mk
+++ b/target/linux/ramips/image/mt7621.mk
@@ -236,6 +236,21 @@ define Device/dlink_dir-860l-b1
endef
TARGET_DEVICES += dlink_dir-860l-b1
+define Device/dlink_dir-878-a1
+ IMAGE_SIZE := 16000k
+ DEVICE_VENDOR := D-Link
+ DEVICE_MODEL := DIR-878
+ DEVICE_VARIANT := A1
+ DEVICE_PACKAGES := kmod-mt7615e kmod-mt7615-firmware wpad-basic
+ KERNEL_INITRAMFS := $$(KERNEL) | uimage-padhdr 96
+ IMAGES += factory.bin
+ IMAGE/sysupgrade.bin := append-kernel | append-rootfs | uimage-padhdr 96 |\
+ pad-rootfs | append-metadata | check-size
+ IMAGE/factory.bin := append-kernel | append-rootfs | uimage-padhdr 96 |\
+ check-size
+endef
+TARGET_DEVICES += dlink_dir-878-a1
+
define Device/d-team_newifi-d2
$(Device/uimage-lzma-loader)
IMAGE_SIZE := 32448k
diff --git a/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds b/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds
index a0f9b2b10d..02f264fb42 100755
--- a/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds
+++ b/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds
@@ -26,7 +26,8 @@ d-team,pbr-m1|\
gehua,ghl-r-001)
ucidef_set_led_netdev "internet" "internet" "$boardname:blue:internet" "wan"
;;
-dlink,dir-860l-b1)
+dlink,dir-860l-b1|\
+dlink,dir-878-a1)
ucidef_set_led_netdev "wan" "wan" "$boardname:green:net" "wan"
;;
gnubee,gb-pc1|\
More information about the lede-commits
mailing list