[openwrt/openwrt] ath79: add support for GL.iNet GL-USB150

LEDE Commits lede-commits at lists.infradead.org
Tue Dec 22 13:13:40 EST 2020


ynezz pushed a commit to openwrt/openwrt.git, branch master:
https://git.openwrt.org/a1b5a43fc4b0edda5bbbb4eb0130ba9160dc515b

commit a1b5a43fc4b0edda5bbbb4eb0130ba9160dc515b
Author: Chen Minqiang <ptpt52 at gmail.com>
AuthorDate: Wed Nov 25 01:53:39 2020 +0800

    ath79: add support for GL.iNet GL-USB150
    
    Add support for the ar71xx supported GL.iNet GL-USB150 to ath79.
    
    GL.iNet GL-USB150 is an USB dongle WiFi router, based on Atheros AR9331.
    
    Specification:
    
    - 400/400/200 MHz (CPU/DDR/AHB)
    - 64 MB of RAM (DDR2)
    - 16 MB of FLASH (SPI NOR)
    - Realtek RTL8152B USB to Ethernet bridge (connected with AR9331 PHY4)
    - 1T1R 2.4 GHz
    - 2x LED, 1x button
    - UART header on PCB
    
    Flash instruction:
    
    Vendor software is based on openwrt so you can flash the sysupgrade
    image via the vendor GUI or using command line sysupgrade utility.
    Make sure to not save configuration over reflash as uci settings
    differ between versions.
    
    Signed-off-by: Chen Minqiang <ptpt52 at gmail.com>
---
 target/linux/ath79/dts/ar9331_glinet_gl-usb150.dts | 120 +++++++++++++++++++++
 .../generic/base-files/etc/board.d/02_network      |   1 +
 target/linux/ath79/image/generic.mk                |   9 ++
 3 files changed, 130 insertions(+)

diff --git a/target/linux/ath79/dts/ar9331_glinet_gl-usb150.dts b/target/linux/ath79/dts/ar9331_glinet_gl-usb150.dts
new file mode 100644
index 0000000000..c75684be04
--- /dev/null
+++ b/target/linux/ath79/dts/ar9331_glinet_gl-usb150.dts
@@ -0,0 +1,120 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "ar9331.dtsi"
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+/ {
+	compatible = "glinet,gl-usb150", "qca,ar9331";
+	model = "GL.iNet GL-USB150";
+
+	aliases {
+		serial0 = &uart;
+		led-boot = &led_power;
+		led-failsafe = &led_power;
+		led-running = &led_power;
+		led-upgrade = &led_power;
+		label-mac-device = &eth0;
+	};
+
+	leds {
+		compatible = "gpio-leds";
+
+		wlan {
+			label = "green:wlan";
+			gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
+			linux,default-trigger = "phy0tpt";
+		};
+
+		led_power: power {
+			label = "green:power";
+			gpios = <&gpio 13 GPIO_ACTIVE_HIGH>;
+			default-state = "on";
+		};
+	};
+
+	keys {
+		compatible = "gpio-keys";
+
+		reset {
+			label = "reset";
+			linux,code = <KEY_RESTART>;
+			gpios = <&gpio 11 GPIO_ACTIVE_HIGH>;
+			debounce-interval = <60>;
+		};
+	};
+
+	gpio-export {
+		compatible = "gpio-export";
+
+		gpio_lan_reset {
+			gpio-export,name = "lan:reset";
+			gpio-export,output = <0>;
+			gpios = <&gpio 7 GPIO_ACTIVE_LOW>;
+		};
+	};
+};
+
+&eth0 {
+	status = "okay";
+
+	mtd-mac-address = <&art 0x0>;
+
+	gmac-config {
+		device = <&gmac>;
+		switch-phy-addr-swap = <0>;
+		switch-phy-swap = <0>;
+	};
+};
+
+&eth1 {
+	status = "okay";
+
+	compatible = "syscon", "simple-mfd";
+};
+
+&spi {
+	status = "okay";
+
+	flash at 0 {
+		compatible = "jedec,spi-nor";
+		spi-max-frequency = <33000000>;
+		reg = <0>;
+
+		partitions {
+			compatible = "fixed-partitions";
+			#address-cells = <1>;
+			#size-cells = <1>;
+
+			partition at 0 {
+				label = "u-boot";
+				reg = <0x000000 0x040000>;
+				read-only;
+			};
+
+			partition at 40000 {
+				label = "u-boot-env";
+				reg = <0x040000 0x010000>;
+			};
+
+			partition at 50000 {
+				compatible = "denx,uimage";
+				label = "firmware";
+				reg = <0x050000 0xfa0000>;
+			};
+
+			art: partition at ff0000 {
+				label = "art";
+				reg = <0xff0000 0x010000>;
+				read-only;
+			};
+		};
+	};
+};
+
+&wmac {
+	status = "okay";
+
+	mtd-cal-data = <&art 0x1000>;
+};
diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network
index e42d889847..e3e0547ee7 100755
--- a/target/linux/ath79/generic/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network
@@ -33,6 +33,7 @@ ath79_setup_interfaces()
 	engenius,ecb1750|\
 	enterasys,ws-ap3705i|\
 	glinet,gl-ar300m-lite|\
+	glinet,gl-usb150|\
 	hak5,wifi-pineapple-nano|\
 	meraki,mr16|\
 	netgear,ex6400|\
diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk
index e44e780e8c..661d4203ed 100644
--- a/target/linux/ath79/image/generic.mk
+++ b/target/linux/ath79/image/generic.mk
@@ -1111,6 +1111,15 @@ define Device/glinet_gl-mifi
 endef
 TARGET_DEVICES += glinet_gl-mifi
 
+define Device/glinet_gl-usb150
+  SOC := ar9331
+  DEVICE_VENDOR := GL.iNET
+  DEVICE_MODEL := GL-USB150
+  IMAGE_SIZE := 16000k
+  SUPPORTED_DEVICES += gl-usb150
+endef
+TARGET_DEVICES += glinet_gl-usb150
+
 define Device/glinet_gl-x750
   SOC := qca9531
   DEVICE_VENDOR := GL.iNet



More information about the lede-commits mailing list