[source] ramips: Add support for Wavlink WL-WN575A3
LEDE Commits
lede-commits at lists.infradead.org
Tue Nov 8 02:17:30 PST 2016
blogic pushed a commit to source.git, branch master:
https://git.lede-project.org/5f6e94855113b0c37fba57eda4af0b0427457b98
commit 5f6e94855113b0c37fba57eda4af0b0427457b98
Author: Roger Pueyo Centelles <roger.pueyo at guifi.net>
AuthorDate: Sun Nov 6 13:00:38 2016 +0100
ramips: Add support for Wavlink WL-WN575A3
This commit adds support for the Wavlink WL-WN575A3, a dual-band wall-plug
wireless router with the following specifications:
- CPU: MediaTek MT7628AN 580MHz
- Flash: 8MB
- RAM: 64MB
- Ethernet: 2x 10/100 Mbps (switched)
- 2.4 GHz: 802.11b/g/n SoC, MIMO 2x2, 20 dBm
- 5 GHz: 802.11a/n/ac MT7612E, MIMO 2x2, 20 dBm
- Antennas: 4x external (2 per radio), non-detachable
- LEDs: 4 programmable + LAN, WAN, POWER
- Buttons: reset, WPS
Flashing instructions:
Factory U-boot launches a TFTP client if WPS button is pressed during power-on.
Rename the sysupgrade file and configure a TFTP as follows:
- Client (WL-WN575A3) IP: 192.168.10.101
- Server IP: 192.168.10.100
- Filename: firmware.bin
Signed-off-by: Roger Pueyo Centelles <roger.pueyo at guifi.net>
---
target/linux/ramips/base-files/etc/board.d/01_leds | 6 +
.../linux/ramips/base-files/etc/board.d/02_network | 1 +
target/linux/ramips/base-files/lib/ramips.sh | 3 +
.../ramips/base-files/lib/upgrade/platform.sh | 1 +
target/linux/ramips/dts/WL-WN575A3.dts | 130 +++++++++++++++++++++
target/linux/ramips/image/mt7628.mk | 7 ++
6 files changed, 148 insertions(+)
diff --git a/target/linux/ramips/base-files/etc/board.d/01_leds b/target/linux/ramips/base-files/etc/board.d/01_leds
index 27e15ca..8d6bb45 100755
--- a/target/linux/ramips/base-files/etc/board.d/01_leds
+++ b/target/linux/ramips/base-files/etc/board.d/01_leds
@@ -312,6 +312,12 @@ whr-600d)
ucidef_set_led_default "power" "power" "$board:green:power" "1"
ucidef_set_led_default "router" "router" "$board:green:router" "1"
;;
+wl-wn575a3)
+ ucidef_set_rssimon "wlan1" "40000" "1"
+ ucidef_set_led_rssi "wifi-low" "wifi-low" "$board:green:wifi-low" "wlan1" "1" "49" "0" "1"
+ ucidef_set_led_rssi "wifi-med" "wifi-med" "$board:green:wifi-med" "wlan1" "50" "84" "0" "1"
+ ucidef_set_led_rssi "wifi-high" "wifi-high" "$board:green:wifi-high" "wlan1" "85" "100" "0" "1"
+ ;;
wrh-300cr)
set_wifi_led "$board:green:wlan"
ucidef_set_led_netdev "lan" "lan" "$board:green:ethernet" "eth0"
diff --git a/target/linux/ramips/base-files/etc/board.d/02_network b/target/linux/ramips/base-files/etc/board.d/02_network
index ece48c0..ecdae63 100755
--- a/target/linux/ramips/base-files/etc/board.d/02_network
+++ b/target/linux/ramips/base-files/etc/board.d/02_network
@@ -90,6 +90,7 @@ ramips_setup_interfaces()
whr-300hp2|\
whr-600d|\
witi|\
+ wl-wn575a3|\
wndr3700v5|\
wsr-1166|\
wsr-600|\
diff --git a/target/linux/ramips/base-files/lib/ramips.sh b/target/linux/ramips/base-files/lib/ramips.sh
index 50bdffc..2560eb7 100755
--- a/target/linux/ramips/base-files/lib/ramips.sh
+++ b/target/linux/ramips/base-files/lib/ramips.sh
@@ -499,6 +499,9 @@ ramips_board_detect() {
*"WL-351 v1 002")
name="wl-351"
;;
+ *"WL-WN575A3")
+ name="wl-wn575a3"
+ ;;
*"WLI-TX4-AG300N")
name="wli-tx4-ag300n"
;;
diff --git a/target/linux/ramips/base-files/lib/upgrade/platform.sh b/target/linux/ramips/base-files/lib/upgrade/platform.sh
index da496e8..7f161f5 100755
--- a/target/linux/ramips/base-files/lib/upgrade/platform.sh
+++ b/target/linux/ramips/base-files/lib/upgrade/platform.sh
@@ -145,6 +145,7 @@ platform_check_image() {
wl-330n3g|\
wl-341v3|\
wl-351|\
+ wl-wn575a3|\
wli-tx4-ag300n|\
wmr-300|\
wnce2001|\
diff --git a/target/linux/ramips/dts/WL-WN575A3.dts b/target/linux/ramips/dts/WL-WN575A3.dts
new file mode 100644
index 0000000..2674824
--- /dev/null
+++ b/target/linux/ramips/dts/WL-WN575A3.dts
@@ -0,0 +1,130 @@
+/dts-v1/;
+#include <dt-bindings/input/input.h>
+#include <dt-bindings/gpio/gpio.h>
+
+#include "mt7628an.dtsi"
+
+/ {
+ compatible = "wavlink,wl-wn575a3", "mediatek,mt7628an-soc";
+ model = "Wavlink WL-WN575A3";
+
+ chosen {
+ bootargs = "console=ttyS0,57600";
+ };
+
+ memory at 0 {
+ device_type = "memory";
+ reg = <0x0 0x4000000>;
+ };
+
+ gpio-keys-polled {
+ compatible = "gpio-keys-polled";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ poll-interval = <20>;
+
+ reset {
+ label = "reset";
+ gpios = <&gpio1 11 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_RESTART>;
+ };
+
+ wps {
+ label = "wps";
+ gpios = <&gpio1 6 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_WPS_BUTTON>;
+ };
+ };
+
+ gpio-leds {
+ compatible = "gpio-leds";
+
+ wifi-high {
+ label = "wl-wn575a3:green:wifi-high";
+ gpios = <&gpio1 5 GPIO_ACTIVE_LOW>;
+ };
+
+ wifi-med {
+ label = "wl-wn575a3:green:wifi-med";
+ gpios = <&gpio0 11 GPIO_ACTIVE_LOW>;
+ };
+
+ wifi-low {
+ label = "wl-wn575a3:green:wifi-low";
+ gpios = <&gpio1 12 GPIO_ACTIVE_LOW>;
+ };
+
+ wps {
+ label = "wl-wn575a3:green:wps";
+ gpios = <&gpio0 4 GPIO_ACTIVE_LOW>;
+ };
+ };
+};
+
+&pinctrl {
+ state_default: pinctrl0 {
+ gpio {
+ ralink,group = "i2c", "wled_an";
+ ralink,function = "gpio";
+ };
+ };
+};
+
+&pcie {
+ status = "okay";
+ pcie-bridge {
+ mt76 at 0,0 {
+ reg = <0x0000 0 0 0 0>;
+ device_type = "pci";
+ mediatek,mtd-eeprom = <&factory 0x8000>;
+ mediatek,2ghz = <0>;
+ };
+ };
+};
+
+&spi0 {
+ status = "okay";
+
+ m25p80 at 0 {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ linux,modalias = "m25p80", "en25q64";
+ spi-max-frequency = <10000000>;
+ m25p,chunked-io = <32>;
+
+ partition at 0 {
+ label = "u-boot";
+ reg = <0x0 0x30000>;
+ read-only;
+ };
+
+ partition at 30000 {
+ label = "u-boot-env";
+ reg = <0x30000 0x10000>;
+ read-only;
+ };
+
+ factory: partition at 40000 {
+ label = "factory";
+ reg = <0x40000 0x10000>;
+ read-only;
+ };
+
+ partition at 50000 {
+ label = "firmware";
+ reg = <0x50000 0x7b0000>;
+ };
+ };
+};
+
+&wmac {
+ status = "okay";
+ ralink,mtd-eeprom = <&factory 0x4>;
+};
+
+ðernet {
+ mtd-mac-address = <&factory 0x2e>;
+ ralink,port-map = "llllw";
+};
diff --git a/target/linux/ramips/image/mt7628.mk b/target/linux/ramips/image/mt7628.mk
index 75fbb3d..7a7ddce 100644
--- a/target/linux/ramips/image/mt7628.mk
+++ b/target/linux/ramips/image/mt7628.mk
@@ -19,6 +19,13 @@ define Device/miwifi-nano
endef
TARGET_DEVICES += miwifi-nano
+define Device/wl-wn575a3
+ DTS := WL-WN575A3
+ IMAGE_SIZE := $(ralink_default_fw_size_8M)
+ DEVICE_TITLE := Wavlink WL-WN575A3
+endef
+TARGET_DEVICES += wl-wn575a3
+
define Device/wrtnode2p
DTS := WRTNODE2P
IMAGE_SIZE := $(ralink_default_fw_size_16M)
More information about the lede-commits
mailing list