[FS#1028] BT Home Hub 5 DSL fails to connect at boot since r4940 (last known working build is r4883)
LEDE Bugs
lede-bugs at lists.infradead.org
Sat Sep 30 09:03:52 PDT 2017
A new Flyspray task has been opened. Details are below.
User who did this - Mauro Mozzarelli (ezplanet)
Attached to Project - LEDE Project
Summary - BT Home Hub 5 DSL fails to connect at boot since r4940 (last known working build is r4883)
Task Type - Bug Report
Category - Base system
Status - Unconfirmed
Assigned To -
Operating System - All
Severity - High
Priority - Very Low
Reported Version - Trunk
Due in Version - Undecided
Due Date - Undecided
Details - The device is BT Home Hub 5
The release is built from SNAPSHOT r4940-00e9a7a
When the router is rebooted DSL fails to sync/connect automatically
If I execute the following commands:
# /etc/init.d/dsl_control stop
and then
# /etc/init.d/dsl_control start
It finally syncs/connects. PPPOA however takes a long time to come up after that (over one minute, ) whilst with previous firmare releases it used to take only a few seconds.
Something changed between r4883 (the last release I have built which is working fine) and r4940. I have not built thus I do not have the releases in between the two indicated.
More information can be found at the following URL:
https://bugs.lede-project.org/index.php?do=details&task_id=1028
More information about the lede-bugs
mailing list