[FS#789] candump exits with "socket: Protocol not supported"
LEDE Bugs
lede-bugs at lists.infradead.org
Tue May 16 14:58:05 PDT 2017
A new Flyspray task has been opened. Details are below.
User who did this - Ken (marconi)
Attached to Project - LEDE Project
Summary - candump exits with "socket: Protocol not supported"
Task Type - Bug Report
Category - Packages
Status - Unconfirmed
Assigned To -
Operating System - All
Severity - Low
Priority - Very Low
Reported Version - Trunk
Due in Version - Undecided
Due Date - Undecided
Details - Supply the following if possible:
- Device problem occurs on
I saw it on an AP121U, but don't think the hardware matters
- Software versions of LEDE release, packages, etc.
LEDE 17.01.1
canutils-candump - 0e3ff3b3-2
- Steps to reproduce
opkg install kmod-can-vcan
ip link add type vcan
ip link set up vcan0
opkg install canutils-candump
candump vcan0
## reports "socket: Protocol not supported"
cansniffer seems to have the same problem (maybe all the "canutils" ?)
"tcpdump -i vcan0" works OK (and with a real CANbus device).
More information can be found at the following URL:
https://bugs.lede-project.org/index.php?do=details&task_id=789
More information about the lede-bugs
mailing list