[PATCH v6 08/34] x86/mm: Add support to enable SME in early boot processing

[Tom Lendacky]

Add support to the early boot code to use Secure Memory Encryption (SME).
Since the kernel has been loaded into memory in a decrypted state, encrypt
the kernel in place and update the early pagetables with the memory
encryption mask so that new pagetable entries will use memory encryption.

The routines to set the encryption mask and perform the encryption are
stub routines for now with functionality to be added in a later patch.

Because of the need to have the routines available to head_64.S, the
mem_encrypt.c is always built and #ifdefs in mem_encrypt.c will provide
functionality or stub routines depending on CONFIG_AMD_MEM_ENCRYPT.

Signed-off-by: Tom Lendacky <thomas.lendacky at amd.com>
---
 arch/x86/kernel/head_64.S |   61 ++++++++++++++++++++++++++++++++++++++++++++-
 arch/x86/mm/Makefile      |    4 +--
 arch/x86/mm/mem_encrypt.c |   26 +++++++++++++++++++
 3 files changed, 86 insertions(+), 5 deletions(-)

diff --git a/arch/x86/kernel/head_64.S b/arch/x86/kernel/head_64.S
index ac9d327..222630c 100644
--- a/arch/x86/kernel/head_64.S
+++ b/arch/x86/kernel/head_64.S
@@ -91,6 +91,23 @@ startup_64:
 	jnz	bad_address
 
 	/*
+	 * Activate Secure Memory Encryption (SME), if supported and enabled.
+	 * The real_mode_data address is in %rsi and that register can be
+	 * clobbered by the called function so be sure to save it.
+	 * Save the returned mask in %r12 for later use.
+	 */
+	push	%rsi
+	call	sme_enable
+	pop	%rsi
+	movq	%rax, %r12
+
+	/*
+	 * Add the memory encryption mask to %rbp to include it in the page
+	 * table fixups.
+	 */
+	addq	%r12, %rbp
+
+	/*
 	 * Fixup the physical addresses in the page table
 	 */
 	addq	%rbp, early_level4_pgt + (L4_START_KERNEL*8)(%rip)
@@ -113,6 +130,7 @@ startup_64:
 	shrq	$PGDIR_SHIFT, %rax
 
 	leaq	(PAGE_SIZE + _KERNPG_TABLE)(%rbx), %rdx
+	addq	%r12, %rdx
 	movq	%rdx, 0(%rbx,%rax,8)
 	movq	%rdx, 8(%rbx,%rax,8)
 
@@ -129,6 +147,7 @@ startup_64:
 	movq	%rdi, %rax
 	shrq	$PMD_SHIFT, %rdi
 	addq	$(__PAGE_KERNEL_LARGE_EXEC & ~_PAGE_GLOBAL), %rax
+	addq	%r12, %rax
 	leaq	(_end - 1)(%rip), %rcx
 	shrq	$PMD_SHIFT, %rcx
 	subq	%rdi, %rcx
@@ -142,6 +161,12 @@ startup_64:
 	decl	%ecx
 	jnz	1b
 
+	/*
+	 * Determine if any fixups are required. This includes fixups
+	 * based on where the kernel was loaded and whether SME is
+	 * active. If %rbp is zero, then we can skip both the fixups
+	 * and the call to encrypt the kernel.
+	 */
 	test %rbp, %rbp
 	jz .Lskip_fixup
 
@@ -162,11 +187,30 @@ startup_64:
 	cmp	%r8, %rdi
 	jne	1b
 
-	/* Fixup phys_base */
+	/*
+	 * Fixup phys_base - remove the memory encryption mask from %rbp
+	 * to obtain the true physical address.
+	 */
+	subq	%r12, %rbp
 	addq	%rbp, phys_base(%rip)
 
+	/*
+	 * Encrypt the kernel if SME is active.
+	 * The real_mode_data address is in %rsi and that register can be
+	 * clobbered by the called function so be sure to save it.
+	 */
+	push	%rsi
+	call	sme_encrypt_kernel
+	pop	%rsi
+
 .Lskip_fixup:
+	/*
+	 * The encryption mask is in %r12. We ADD this to %rax to be sure
+	 * that the encryption mask is part of the value that will be
+	 * stored in %cr3.
+	 */
 	movq	$(early_level4_pgt - __START_KERNEL_map), %rax
+	addq	%r12, %rax
 	jmp 1f
 ENTRY(secondary_startup_64)
 	/*
@@ -186,7 +230,20 @@ ENTRY(secondary_startup_64)
 	/* Sanitize CPU configuration */
 	call verify_cpu
 
-	movq	$(init_level4_pgt - __START_KERNEL_map), %rax
+	/*
+	 * Get the SME encryption mask.
+	 *  The encryption mask will be returned in %rax so we do an ADD
+	 *  below to be sure that the encryption mask is part of the
+	 *  value that will stored in %cr3.
+	 *
+	 * The real_mode_data address is in %rsi and that register can be
+	 * clobbered by the called function so be sure to save it.
+	 */
+	push	%rsi
+	call	sme_get_me_mask
+	pop	%rsi
+
+	addq	$(init_level4_pgt - __START_KERNEL_map), %rax
 1:
 
 	/* Enable PAE mode and PGE */
diff --git a/arch/x86/mm/Makefile b/arch/x86/mm/Makefile
index 44d4d21..88ee454 100644
--- a/arch/x86/mm/Makefile
+++ b/arch/x86/mm/Makefile
@@ -2,7 +2,7 @@
 KCOV_INSTRUMENT_tlb.o	:= n
 
 obj-y	:=  init.o init_$(BITS).o fault.o ioremap.o extable.o pageattr.o mmap.o \
-	    pat.o pgtable.o physaddr.o gup.o setup_nx.o tlb.o
+	    pat.o pgtable.o physaddr.o gup.o setup_nx.o tlb.o mem_encrypt.o
 
 # Make sure __phys_addr has no stackprotector
 nostackp := $(call cc-option, -fno-stack-protector)
@@ -38,5 +38,3 @@ obj-$(CONFIG_NUMA_EMU)		+= numa_emulation.o
 obj-$(CONFIG_X86_INTEL_MPX)	+= mpx.o
 obj-$(CONFIG_X86_INTEL_MEMORY_PROTECTION_KEYS) += pkeys.o
 obj-$(CONFIG_RANDOMIZE_MEMORY) += kaslr.o
-
-obj-$(CONFIG_AMD_MEM_ENCRYPT)	+= mem_encrypt.o
diff --git a/arch/x86/mm/mem_encrypt.c b/arch/x86/mm/mem_encrypt.c
index b99d469..cc00d8b 100644
--- a/arch/x86/mm/mem_encrypt.c
+++ b/arch/x86/mm/mem_encrypt.c
@@ -11,6 +11,9 @@
  */
 
 #include <linux/linkage.h>
+#include <linux/init.h>
+
+#ifdef CONFIG_AMD_MEM_ENCRYPT
 
 /*
  * Since SME related variables are set early in the boot process they must
@@ -19,3 +22,26 @@
  */
 unsigned long sme_me_mask __section(.data) = 0;
 EXPORT_SYMBOL_GPL(sme_me_mask);
+
+void __init sme_encrypt_kernel(void)
+{
+}
+
+unsigned long __init sme_enable(void)
+{
+	return sme_me_mask;
+}
+
+unsigned long sme_get_me_mask(void)
+{
+	return sme_me_mask;
+}
+
+#else	/* !CONFIG_AMD_MEM_ENCRYPT */
+
+void __init sme_encrypt_kernel(void)	{ }
+unsigned long __init sme_enable(void)	{ return 0; }
+
+unsigned long sme_get_me_mask(void)	{ return 0; }
+
+#endif	/* CONFIG_AMD_MEM_ENCRYPT */