[PATCH] kexec: force x86_64 arches to boot kdump kernels on boot cpu

[Yinghai Lu]

On Dec 6, 2007 4:33 PM, Eric W. Biederman <ebiederm at xmission.com> wrote:
> Vivek Goyal <vgoyal at redhat.com> writes:
>
>
> > On Thu, Dec 06, 2007 at 04:39:51PM -0500, Neil Horman wrote:
> >> On Fri, Nov 30, 2007 at 09:51:31AM -0500, Neil Horman wrote:
> >> > On Fri, Nov 30, 2007 at 09:42:50AM -0500, Vivek Goyal wrote:
> >> <snip>
> >> >
> >> > Thats what I'm doing at the moment.  I'm working on a RHEL5 patch at the
> > moment
> >> > (since thats whats on the production system thats failing), and will forward
> >> > port it once its working
> >> >
> >> > And not to split hairs, but techically thats not our _only_ choice.  We
> > could
> >> > force kdump boots on cpu0 as well ;)
> >> >
> >> > Thanks
> >> > Neil
> >> >
> >> > > Thanks
> >> > > Vivek
> >> >
> >>
> >>
> >> Sorry to have been quiet on this issue for a few days. Interesting news to
> >> report, though.  So I was working on a patch to do early apic enabling on
> >> x86_64, and had something working for the old 2.6.18 kernel that we were
> >> origionally testing on.  Unfortunately while it worked on 2.6.18 it failed
> >> miserably on 2.6.24-rc3-mm2, causing check_timer to consistently report that
> > the
> >> timer interrupt wasn't getting received (even though we could successfully run
> >> calibrate_delay).  Vivek and I were digging into this, when I ran accross the
> >> description of the hypertransport configuration register in the opteron
> >> specification.  It contains a bit that, suprise, configures the ht bus to
> > either
> >> unicast interrupts delivered accross the ht bus to a single cpu, or to
> > broadcast
> >> it to all cpus.  Since it seemed more likely that the 8259 in the nvidia
> >> southbridge was transporting legacy mode interrupts over the ht bus than
> >> directly to cpu0 via an actual wire, I wrote the attached patch to add a quirk
> >> for nvidia chipsets, which scanned for hypertransport controllers, and ensured
> >> that that broadcast bit was set.  Test results indicate that this solves the
> >> problem, and kdump kernels boot just fine on the affected system.
> >>
> >
> > Hi Neil,
> >
> > Should we disable this broadcasting feature once we are through? Otherwise
> > in normal systems it might mean extra traffic on hypertransport. There
> > is no need for every interrupt to be broadcasted in normal systems?
>
> My feel is that if it is for legacy interrupts only it should not be a problem.
> Let's investigate and see if we can unconditionally enable this quirk
> for all opteron systems.

i checked that bit

http://www.openbios.org/viewvc/trunk/LinuxBIOSv2/src/northbridge/amd/amdk8/coherent_ht.c?revision=2596&view=markup

static void enable_apic_ext_id(u8 node)
{
#if ENABLE_APIC_EXT_ID==1
#warning "FIXME Is the right place to enable apic ext id here?"

      u32 val;

        val = pci_read_config32(NODE_HT(node), 0x68);
        val |= (HTTC_APIC_EXT_SPUR | HTTC_APIC_EXT_ID | HTTC_APIC_EXT_BRD_CST);
        pci_write_config32(NODE_HT(node), 0x68, val);
#endif
}

that bit only be should be set when apic id is lifted and cpu apid is
using 8 bits and that mean broadcast is 0xff instead 0x0f.
for example 8 socket dual core system or 4 socket quad core
system,that you should make BSP start from 0x04, so cpus apic id will
be [0x04, 0x13)


So if you want to enable that in early_quirk, you need to
make sure apic id is using 8 bits by check if the bit 16 (HTTC_APIC_ID) is set.

most BIOS already did that. You may ask Supermicro fix their broken
BIOS instead.

YH